Fujitsu Siemens Computers 19T2 manual Data cable

Color monitor 19T2

1	2	1 =	Power connector
		2 =	Data cable

ÊBe sure that the monitor and the system unit are switched off.

!

The system unit's power plug must be pulled out!

ÊConnect the connector of the data cable to the (active) monitor port on the system unit and secure the plug-in connection by tightening the safety screws.

i

Ê

Ê

Ê

i

If your system unit has two monitor ports ("onboard" screen controller and separate graphics card), the monitor port for the separate graphics card is usually active.

Plug the power cable supplied into the power connector (1) of the monitor.

Plug the power connector of the monitor into a properly grounded power outlet.

Plug the power connector of the system unit into a properly grounded power outlet.

When you start working with your monitor for the first time you should install the appropriate graphics drivers for your application software. Details of how to do this are provided in the documentation on your screen controller/the associated driver software.

A26361-K616-Z100-2-5E19 English - 7