Fujitsu Siemens Computers 19T2 manual Changing the monitor settings

Page 17

Color monitor 19T2

If your PC detects inactivity (no input) it sends an appropriate signal to the monitor to reduce the power consumption. The power indicator of the monitor changes color to indicate the status change. If there is still no input, power consumption is further reduced (OFF mode).

Once an input is made at the PC the screen contents are redrawn and full power is restored.

The length of the individual stages is determined by the power management system of the PC. For detailed information on how energy-saving mode operates refer to the Operating Manual or Technical Manual of your PC.

The service life of your monitor will be extended if the OFF mode is switched to after 30 i minutes at the earliest (setting in screen saver, in your PC's BIOS setup or in the OSD

menu).

When the monitor is switched to OFF mode by the power management system a power consumption of about 3 W is maintained to feed the circuit for redrawing the screen contents.

To cut off power consumption totally, press the ON/OFF switch on the front of the monitor.

Changing the monitor settings

With the buttons on the control panel, you can change the monitor settings. Most settings are carried out via an integrated OSD menu (On-Screen Display).

The OSD menu is available in different languages. The English menu names are used in i the following description (default setting). How you set a different language for the OSD

menu is described in the section "Setting the language for the OSD menu (LANGUAGE)".

 

1

2

3

4

5

1 =

Factory settings button

3 = Brightness/arrow up/down button

2 =

Picture size/position button

4 =

Menu button

 

(automatic setting)

5 = Contrast/arrow left/right button

The factory settings button (1) is used to reset the values to the factory settings.

With the picture size/position button (2) the screen display can be automatically adjusted so that it fits on the screen. This function is especially intended for computers with graphic user interfaces (software) which fills the entire screen.

The brightness/arrow up/down buttons (3) are used to set the brightness and to operate the OSD menu.

The menu button (4) switches the OSD menu on and off.

The contrast/arrow left/right buttons (5) are used to set the contrast and to operate the OSD menu.

A26361-K616-Z100-2-5E19

English - 9

Image 17
Contents 19T2 Sie haben Page A26361-K616-Z100-1-5E19 Ausgabe Juli 2000 July 2000 edition Betriebsanleitung Operating ManualPage Contents Page Notational conventions IntroductionTarget group Further informationImportant notes SafetyManufacturers notes Cleaning note19T2Transport notes Energy StarFor the United Kingdom Important note on power cableChecking the contents of the consignment Connecting the monitor Installing an ergonomic video workstationData cable Operation of the monitor Switching the monitor onSwitching the monitor off Changing the monitor settings Operating the OSD menu Adjusting the contrast and brightnessSetting the picture geometry Geometry Setting picture position and size SIZE/CENTERSetting convergence Convergence Setting color temperature and colors ColorSetting monitor options Option Setting language for the OSD menu LanguageOpen Help menu Help Activating the factory settingsResetting a selected function to the factory setting Resetting all settings for all input signals Resetting all settings for the current input signalDimensions and weight Technical dataAccessories Storable display modes Electrical data Environmental conditionsVESA-DDC-compatible VGA interface Preset operating modesPin Meaning Pin assignment D-SUB 15-pinTilting and turning area Possible malfunctions Error handlingSelf-diagnosis Monitor adjustment buttons do not react Two fine horizontal lines wires are visibleScreen display is too small or not centered Picture geometry is defectiveHumming noise is heard after switch-on Error messages on the screen