Fujitsu Siemens Computers 19T2 manual Operation of the monitor, Switching the monitor on

Page 16

Color monitor 19T2

Operation of the monitor

2	3
1

1 = Control panel with buttons for screen setting

2 = Power indicator

3 = ON/OFF switch

Switching the monitor on

ÊPress the ON/OFF switch (3).

The power indicator (2) lights up green when the system unit is turned on.

i	If your PC has a power management function (energy-saving mode), you should read the
i	"Notes on power management" of the monitor in this chapter.
	When you start your system, several mode changes will usually be carried out when
	various programs are called automatically (different settings for resolution and image
	refresh rate). Do not be confused by the unusual displays. They are not error messages.

Switching the monitor off

ÊPress the ON/OFF switch (3). The power indicator (2) is dark.

Notes on power management

If your PC has a VESA DPMS (Video Electronics Standard Association, Display Power Management Signaling) power management function (energy-saving mode), your monitor will fully support this function. The monitor has a four-stage power management system.

Stage	ON	Standby mode	Suspend mode	OFF mode

Power indicator	glows green	flashes green/orange	flashes green/orange	glows orange

Function	Monitor operating	Monitor	Monitor	Monitor
	normally	is dark	is dark	is dark

Power	normal	reduced	reduced	reduced
consumption	< 140 W	to < 15 W	to < 15 W	to < 3 W

8 - English

A26361-K616-Z100-2-5E19

Image 16

Contents 19T2 Sie haben Page A26361-K616-Z100-1-5E19 Betriebsanleitung Operating Manual Ausgabe Juli 2000 July 2000 editionPage Contents Page Introduction Notational conventionsTarget group Further informationSafety Important notesCleaning note19T2 Manufacturers notesTransport notes Energy StarImportant note on power cable For the United Kingdom Checking the contents of the consignment Installing an ergonomic video workstation Connecting the monitorData cable Switching the monitor off Switching the monitor onOperation of the monitor Changing the monitor settings Adjusting the contrast and brightness Operating the OSD menuSetting picture position and size SIZE/CENTER Setting the picture geometry GeometrySetting color temperature and colors Color Setting convergence ConvergenceSetting language for the OSD menu Language Setting monitor options OptionResetting a selected function to the factory setting Activating the factory settingsOpen Help menu Help Resetting all settings for the current input signal Resetting all settings for all input signalsTechnical data Dimensions and weightAccessories Storable display modes Electrical data Environmental conditionsPreset operating modes VESA-DDC-compatible VGA interfaceTilting and turning area Pin assignment D-SUB 15-pinPin Meaning Self-diagnosis Error handlingPossible malfunctions Two fine horizontal lines wires are visible Monitor adjustment buttons do not reactScreen display is too small or not centered Picture geometry is defectiveError messages on the screen Humming noise is heard after switch-on