Fujitsu Siemens Computers 19T2 Technical data, Dimensions and weight, Environmental conditions

Page 24

Color monitor 19T2

Technical data

Dimensions and weight

CRT:

Visible diagonals:

Dot pitch:

Maximal resolution: Preset display area: Dimensions (W x H x D): Weight:

Accessories:

Storable display modes:

Electrical data

Video:

Synchronization:

Horizontal frequency:

Refresh rate:

Maximum pixel rate:

Power supply:

Power consumption:

(see power management):

Environmental conditions

Environment class 3K2, IEC 721

Rated range of operation: Humidity:

Limit range of operation:

Humidity:

Condensation must be avoided.

46 cm (19")

46 cm

0.24- 0.25 mm (slot mask) 1600 x 1200 pixels

352 mm x 264 mm

449 mm x 463 mm x 463 mm

26 kg

Power cable (1.8 m)

25 (10 of which are preset)

analog, positive, 0.7 Vpp, 75 Ohm

Separate Sync. TTL

Composite Sync. TTL/ Sync. on Green

30 kHz

.... 107 kHz (multi-scanning)

48 Hz ....

120 Hz

230 MHz

180 V -264 V, 50 Hz - 60 Hz ± 3 Hz,

<1 A max. at 220 V

<145 W (ON, Normal mode)

<15 W (Standby mode)

<15 W (Suspend mode)

<3 W (OFF mode)

15 °C

.... 35 °C

20 %

.... 85 %

5 °C ....

40 °C

20 %

.... 85 %

16 - English

A26361-K616-Z100-2-5E19

Image 24
Contents 19T2 Sie haben Page A26361-K616-Z100-1-5E19 Betriebsanleitung Operating Manual Ausgabe Juli 2000 July 2000 editionPage Contents Page Introduction Notational conventionsTarget group Further informationSafety Important notesCleaning note19T2 Manufacturers notesTransport notes Energy StarImportant note on power cable For the United KingdomChecking the contents of the consignment Installing an ergonomic video workstation Connecting the monitorData cable Switching the monitor on Switching the monitor offOperation of the monitor Changing the monitor settings Adjusting the contrast and brightness Operating the OSD menuSetting picture position and size SIZE/CENTER Setting the picture geometry GeometrySetting color temperature and colors Color Setting convergence ConvergenceSetting language for the OSD menu Language Setting monitor options OptionActivating the factory settings Resetting a selected function to the factory settingOpen Help menu Help Resetting all settings for the current input signal Resetting all settings for all input signalsTechnical data Dimensions and weightAccessories Storable display modes Electrical data Environmental conditionsPreset operating modes VESA-DDC-compatible VGA interfacePin assignment D-SUB 15-pin Tilting and turning areaPin Meaning Error handling Self-diagnosisPossible malfunctions Two fine horizontal lines wires are visible Monitor adjustment buttons do not reactScreen display is too small or not centered Picture geometry is defectiveError messages on the screen Humming noise is heard after switch-on