Permanently unlit or lit pixels

Colour monitor 4312 FA

No display (power indicator lights)

ÊCheck whether the system unit is switched on.

ÊCheck whether the data cable for the monitor is correctly attached to the monitor and the monitor port on the system unit.

ÊPress any key on the PC keyboard - the PC may be in energy saving mode.

ÊAlter the brightness and/or contrast until you get a picture.

Picture disturbances (vertical and horizontal lines, picture noise)

ÊFirst in the Image Lock setting window, set the Coarse function to remove any vertical bars.

ÊThen set the Fine function in the Image Lock setting window to eliminate the picture noise or the horizontal lines.

If one of the operating systems Windows for Workgroups, Windows 95/98, Windows NT i or OS/2 (with Windows emulation installed) is used, the monitor can be adjusted with the

floppy disk supplied.

The standard of production techniques today cannot guarantee an absolutely fault-free screen display. A few isolated constant lit or unlit pixels may be present. The maximum permitted number of pixels faults is stipulated in the stringent international standard ISO 13406-2 (Class II).

Example: a 17" flat-screen monitor with a resolution of 1024 x 1280 has 1024 x 1280 = 1310720 pixels. Each pixel consists of three subpixels (red, green and blue), so there are about 4 million dots in total.

According to ISO 13406-2 (Class II), a maximum of 6 pixels and 7 subpixels may be defective, i. e. a total of 25 faulted dots. This corresponds to approx. 0,00062 % of the entire screen surface!

The flat screen monitors from Fujitsu Siemens Computers are typically considerably better than requirements defined in this standard.

The screen becomes darker

The background lighting has a limited lifetime. If your monitor display should become too dark, the background lighting will have to be exchanged. Please contact our customer service centre.

S26361-K841-V150-1-5E19

English - 21