Cisco Systems OL-17037-01 manual Display of MAC Addresses for Converted Access Points

Chapter 7 Controlling Lightweight Access Points

Autonomous Access Points Converted to Lightweight Mode

Using the CLI to Upload Access Point Core Dumps

Using the controller CLI, follow these steps to upload a core dump file of the access point.

Step 1 To upload a core dump of the access point, enter this command on the controller:

config ap core-dump enable tftp_server_ip_address filename {compress uncompress} {ap_name all}

where

•tftp_server_ip_address is the IP address of the TFTP server to which the access point sends core dump files,

Note The access point must be able to reach the TFTP server.

•filename is the name that the access points uses to label the core file,

•compress configures the access point to send compressed core files whereas uncompress configures the access point to send uncompressed core files, and

Note When you choose compress, the file is saved with a .gz extension (for example, dump.log.gz). This file can be opened with WinZip.

•ap_name is the name of a specific access point for which core dumps are uploaded whereas all is all access points converted to lightweight mode.

Step 2 To save your changes, enter this command:

save config

Display of MAC Addresses for Converted Access Points

There are some differences in the way that controllers display the MAC addresses of converted access points on information pages in the controller GUI:

•On the AP Summary page, the controller lists the Ethernet MAC addresses of converted access points.

•On the AP Detail page, the controller lists the BSS MAC addresses and Ethernet MAC addresses of converted access points.

•On the Radio Summary page, the controller lists converted access points by radio MAC address.

	Cisco Wireless LAN Controller Configuration Guide
7-32	OL-17037-01