Cisco Systems OL-17037-01 manual Sample WGB Configuration, Show dot11 association

Chapter 7 Controlling Lightweight Access Points

Cisco Workgroup Bridges

•These features are not supported for wired clients connected to a WGB:

–MAC filtering

–Link tests

–Idle timeout

•To enable the WGB to communicate with the lightweight access point, create a WLAN and make sure that Aironet IE is enabled.

Sample WGB Configuration

Here is a sample configuration of a WGB access point using static WEP with a 40-bit WEP key:

ap#configure terminal

Enter configuration commands, one per line. End with CNTL/Z. ap(config)#dot11 ssid WGB_with_static_WEP ap(config-ssid)#authentication open ap(config-ssid)#guest-mode

ap(config-ssid)#exit ap(config)#interface dot11Radio 0 ap(config)#station-role workgroup-bridge ap(config-if)#encry mode wep 40 ap(config-if)#encry key 1 size 40 0 1234567890 ap(config-if)#WGB_with_static_WEP ap(config-if)#end

To verify that the WGB is associated to an access point, enter this command on the WGB:

show dot11 association

Information similar to the following appears:

ap#show dot11 associations

802.11Client Stations on Dot11Radio0:

SSID [FCVTESTING] :

MAC	Address	IP address	Device	Name	Parent	State
000b.8581.6aee		10.11.12.1	WGB-client	map1	-	Assoc
ap#

Using the GUI to View the Status of Workgroup Bridges

Follow these steps to view the status of WGBs on your network using the controller GUI.

Step 1 Click Monitor > Clients to open the Clients page (see Figure 7-10).

	Cisco Wireless LAN Controller Configuration Guide
OL-17037-01		7-37