Cisco Systems OL-17037-01 manual Controlling Lightweight Access Points Viewing Clients

Chapter 7 Controlling Lightweight Access Points

Viewing Clients

Figure 7-27 Clients Page

This page lists all of the clients that are associated to the controller’s access points. It provides the following information for each client:

•The MAC address of the client

•The name of the access point to which the client is associated

•The name of the WLAN used by the client

•The type of client (802.11a, 802.11b, 802.11g, or 802.11n)

Note If the 802.11n client associates to an 802.11a radio that has 802.11n enabled, then the client type shows as 802.11n(5). If the 802.11n client associates to an 802.11b/g radio with 802.11n enabled, then the client type shows as 802.11n (2.4).

•The status of the client connection

•The authorization status of the client

•The port number of the access point to which the client is associated

•An indication of whether the client is a WGB

Note Refer to the “Cisco Workgroup Bridges” section on page 7-34for more information on the WGB status.

Note If you want to remove or disable a client, hover your cursor over the blue drop-down arrow for that client and choose Remove or Disable, respectively. If you want to test the connection between the client and the access point, hover your cursor over the blue drop-down arrow for that client and choose Link Test.

Step 2 To create a filter to display only clients that meet certain criteria (such as MAC address, status, or radio type), follow these steps:

a.Click Change Filter to open the Search Clients page (see Figure 7-28).

	Cisco Wireless LAN Controller Configuration Guide
OL-17037-01		7-75