Chapter 7 Controlling Lightweight Access Points
Configuring Country Codes
Step 9 If you entered multiple country codes in Step 3, follow these steps to assign each access point to a specific country:
a.Perform one of the following:
–Leave the 802.11a and 802.11b/g networks disabled.
–
config 802.11a enable network config 802.11b enable network
To disable an access point, enter this command: config ap disable ap_name
b.To assign an access point to a specific country, enter this command: config ap country code {ap_name all}
Make sure that the country code you choose is compatible with the regulatory domain of at least one of the access point’s radios.
Note If you enabled the networks and disabled some access points and then run the config ap country code all command, the specified country code is configured on only the disabled access points. All other access points are ignored.
For example, if you enter config ap country mx all, information similar to the following appears:
To change country code: first disable target AP(s) (or disable all networks).
Changing the country may reset any customized channel assignments.
Changing the country will reboot disabled target AP(s).
Are you sure you want to continue? (y/n) y
AP Name | Country | Status |
ap2 | US | enabled (Disable AP before configuring country) |
ap1 | MX | changed (New country configured, AP rebooting) |
c.To
Step 10 If you did not
config 802.11a enable network config 802.11b enable network
Step 11 To save your settings, enter this command:
save config
| Cisco Wireless LAN Controller Configuration Guide |