Cisco Systems OL-20932-02 manual Changing the User Password

Chapter 2 Installing and Configuring the Cisco Physical Access Gateway

Configuring and Managing the Gateway Using a Direct Connection

Step 6 Perform additional configuration, verification, and monitoring tasks as described in the Cisco Physical Access Manager User Guide.

Changing the User Password

Tip You can also change the password for one or more Gateways using the Cisco PAM desktop software. See the “Changing Gateway Passwords” section in the Cisco Physical Access Manager User Guide for more information.

Procedure

To change the password used to access the Gateway, do the following:

Step 1 Click the User Management tab, as shown in Figure 2-14.

Figure 2-14 User Management for the Cisco Physical Access Gateway

Step 2 Enter the Current Password.

Step 3 Enter the New Password.

Step 4 Re-enterthe new password to verify the setting.

Step 5 Click Update to save the changes.

Note The Username cannot be changed.

Tip To reset the device to the default password, see the “Hard Reset (Restore Factory Defaults)” section on page 2-24.

	Cisco Physical Access Gateway User Guide
OL-20932-02		2-19