Cisco Systems UBR7225VXR specifications

Page 2

THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY, CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY.

The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to correct the interference at their own expense.

The following information is for FCC compliance of Class B devices: The equipment described in this manual generates and may radiate radio-frequency energy. If it is not installed in accordance with Cisco’s installation instructions, it may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B digital device in accordance with the specifications in part 15 of the FCC rules. These specifications are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation.

Modifying the equipment without Cisco’s written authorization may result in the equipment no longer complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense.

You can determine whether your equipment is causing interference by turning it off. If the interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following measures:

Turn the television or radio antenna until the interference stops.

Move the equipment to one side or the other of the television or radio.

Move the equipment farther away from the television or radio.

Plug the equipment into an outlet that is on a different circuit from the television or radio. (That is, make certain the equipment and the television or radio are on circuits controlled by different circuit breakers or fuses.)

Modifications to this product not authorized by Cisco Systems, Inc. could void the FCC approval and negate your authority to operate the product.

The Cisco implementation of TCP header compression is an adaptation of a program developed by the University of California, Berkeley (UCB) as part of UCB’s public domain version of the UNIX operating system. All rights reserved. Copyright © 1981, Regents of the University of California.

NOTWITHSTANDING ANY OTHER WARRANTY HEREIN, ALL DOCUMENT FILES AND SOFTWARE OF THESE SUPPLIERS ARE PROVIDED “AS IS” WITH ALL FAULTS. CISCO AND THE ABOVE-NAMED SUPPLIERS DISCLAIM ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION, THOSE OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OR ARISING FROM A COURSE OF DEALING, USAGE, OR TRADE PRACTICE.

IN NO EVENT SHALL CISCO OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES, INCLUDING, WITHOUT LIMITATION, LOST PROFITS OR LOSS OR DAMAGE TO DATA ARISING OUT OF THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF CISCO OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)

Cisco uBR7225VXR Universal Broadband Router Hardware Installation Guide

Copyright © 2008-2009, 2012 Cisco Systems, Inc.

All rights reserved.

Image 2
Contents Americas Headquarters Text Part Number OL-17309-02Page N T E N T S AC Power Measuring the Downstream RF Signal at the Upconverter Output Maintaining the Cisco uBR7225VXR Router Coaxial Cables C-1 Viii Document Objectives PrefaceDocument Revision History Revision Date Change SummaryChapter Title Description AudienceDocument Organization Document Conventions Appendix G, Site LogObtaining Documentation and Submitting a Service Request Cisco uBR7225VXR Overview Cisco uBR7225VXR Universal Broadband RouterOL-17309-02 Cisco uBR7225VXR Router Chassis Cable interface line card slotCisco uBR7225VXR Network Interface Overview Card Slot and Logical Interface NumberingMAC-Layer Address Cisco uBR7255VXR Chassis and Cable Interface Line CardsSupported System Configurations Overview Basic Internet Access ServicesTwo-Way HFC Cable Network Example VPN Services IP Telephony ServicesTelco Return HFCHardware Component Descriptions Network Processing EngineNPE Comparisons Cisco Cable Interface Line Cards Power Supplies Cisco uBR7225VXR AC-Input Power Supply Fan TraysCisco uBR7225VXR Fan Tray Internal Airflow-Top View Cisco uBR7225VXR Chassis Subchassis and MidplaneCompactFlash Disk Top BackCisco uBR7225VXR Overview Hardware Component Descriptions OL-17309-02 Installation Safety RecommendationsLifting the Cisco uBR7225VXR Router Safely Safety with Electricity Lifting the Chassis Cisco uBR7246 Router ShownPreventing Electrostatic Discharge Damage Site Environment AC PowerSite Requirements Specification Minimum Maximum Site Configuration Maintaining Normal OperationGeneral Precautions Before You Begin Power ConsiderationsRequired Network Information Installation Tools Rack-Mount and Cable-Management KitEquipment Required to Verify Your Plant’s RF Setup Shipping Container ContentsProvisioning the Cable Headend Two-Way Data and VoIPReceivers Headend CertificationDiplex Filters Dial-Up/Remote Access Servers DHCP, DNS, TFTP, and TD ServersVoIP Sgcp Pass-Through Authentication, Authorization, and Accounting ServersVoIP Gateways and Gatekeepers Headend Wiring Interference ConsiderationsEquipment Racks 17.32 23.875 21.875 Site Preparation Checklist Task Verified By DateComponent Checklists Task Verified By DateInstalling the Cisco uBR7225VXR Router Cisco uBR7225VXR Router Installation ChecklistCisco uBR7225VXR Router Chassis Rack-Mounting Options Typical 4-Post Equipment Rack Posts and Mounting Strips Rack-mount bracket Installing the Chassis in a Telco-Type Rack Cable-Management Bracket RequirementsRack-mount bracket Cable-management bracket Installing the Brackets on the Chassis Installing Rack-Mount Brackets on the Rear of the ChassisInstalling Rack-Mount Brackets on the Front of the Chassis Installing Rack-Mount Brackets in the Middle of the Chassis Installing the Chassis in the Rack OL-17309-02 OL-17309-02 Cabling Connecting Cable Interface Line Card Cables Console and Auxiliary Port Connection EquipmentPin Signal Direction Description Console Port SignalsAuxiliary Port Signals Connecting Power Protective GroundingConnecting to the AC-Input Power Supply Powering On the Cisco uBR7225VXR Router 14 Connecting AC-Input PowerConfiguring the Interfaces OL-17309-02 Connecting the Cisco uBR7225VXR Router to the Cable Headend Two-Way Data Headend Architecture One-Way Data Headend Architecture RF and Digital Data OverviewInstalling and Configuring the Upconverter Connecting and Configuring the DownstreamMeasuring the Downstream RF Signal Page Viewing the Downstream if Signal on a Spectrum Analyzer Measuring the Downstream RF Signal at the Upconverter Output Overloaded Spectrum Analyzer Input Page OL-17309-02 OL-17309-02 OL-17309-02 OL-17309-02 OL-17309-02 OL-17309-02 OL-17309-02 OL-17309-02 Docsis Specification Connecting and Configuring the UpstreamConnecting the Upstream to the Optical Receiver Channel Bandwidth Cisco MC11 FpgaTesting the Upstream Configuration 30 km Fiber node Milliwatt Measure +10 dBmV at this pointOptical receiver Downstream Optical +10 dBmV Receiver +13 dBmV Attenuator Measuring the Upstream RF Signal Measuring the Upstream RF Signal Using a Spectrum AnalyzerOL-17309-02 OL-17309-02 Analyzing the Upstream RF Signal 29 Analyzing the Upstream RF Signal-64-Byte Data Packets30 Analyzing the Upstream RF Signal-1500-Byte Data Packets OL-17309-02 Symbol Rate +/-1/2 Symbol Rate Bandwidth Using the Zero-Span Method with Adjacent Upstream ChannelsCenter Frequency Minimum Resolution OL-17309-02 35 Vector Signal Analyzer Plot of Upstream Data Burst OL-17309-02 OL-17309-02 OL-17309-02 39 Preamble Amplitude Before Center Frequency Adjustment 41 Original Preamble Viewed with Accelerated Sweep Time OL-17309-02 Connecting the Cisco uBR7225VXR Router to the Cable Headend OL-17309-02 Connecting the Cisco uBR7225VXR Router to the Cable Headend Configuring the Digital Signal OL-17309-02 OL-17309-02 Maintaining the Cisco uBR7225VXR Router Online Insertion and RemovalEnvironmental Monitoring and Reporting Functions Environmental MonitoringReporting Functions Parameter High Warning High Critical ShutdownRouter# show environment Temperature ranges and values are subject to change Fan Failures Providing Information TroubleshootingOverview Problem Solving with Subsystems Troubleshooting Problem Solving with SubsystemsIdentifying Startup Problems Power Subsystem Cooling SubsystemTroubleshooting the Network Processing Engine Processor SubsystemTroubleshooting Cable Interface Line Cards Verifying the Downstream Signal Other Troubleshooting Information WebsitesTroubleshooting Verifying the Downstream Signal Cisco uBR7225VXR Router Specifications Description SpecificationBroadband Routers at the following URL Bandwidth, MHz Msym/sec Mbps Rate, Mbps RF SpecificationsChannel Symbol Rate Raw Data Rate Nominal Data Channel Qpsk RawParameter Value Docsis 1.0 Transmission CharacteristicsDownstream RF Channel Transmission Characteristics Upstream RF Channel Transmission Characteristics Docsis 1.1 Transmission Characteristics EuroDOCSIS Transmission Characteristics Downstream RF Channel Transmission Characteristics Upstream RF Channel Transmission Characteristics Electrical Input and Output Parameter Value OL-17309-02 Cable Specifications Coaxial CablesConsole and Auxiliary Port Cables and Pinouts Identifying an RJ-45 Rollover CableConsole Port Cables and Pinouts RJ-45-to-DB-9Identifying an RJ-45 Crossover Cable Fast Ethernet Port Cables and PinoutsAuxiliary Port Cables and Pinouts RJ-45 Pin Description Identifying an RJ-45 Straight-Through CableRJ-45 Pin Fiber-Optic Cables and Connectors Figure C-5 Duplex SC Cable ConnectorIndustry-Standard Wiring Plans About Wiring StandardsPosition Color Optical Fiber Color CodesTIA/EIA Standards Information Telephone Wire Color Codes Pair Number Wire Number Solid Color Stripe Color Pin NumberPair Number Wire Number Solid Color Stripe Color Pin Number Pair Number Wire Number Solid Color Stripe Color White Blue Green Red Orange Black YellowOL-17309-02 Frequency Allocation Tables Http//developer.apple.com Http//atxnetworks.comStandards Comparisons B1, G D1, KNtsc Cable Television Channels and Relative Frequencies Freq MHz Carrier Visual Aural Table E-4 Freq MHz Carrier Visual Aural Table E-4 Ntsc M Cable Television Frequencies for Japan Table E-5 Japanese Channel Assignments PAL/SECAM Cable Television Channels and Relative Frequencies Bandwidth Visual Carrier Aural CarrierChannel Channel Bandwidth Visual Carrier Aural Carrier Number MHz Table E-6 OL-17309-02 Manufacturer Website or Phone Number Products/Model Manufacturers for Headend Provisioning RequirementsNorth American Channel Plans Agilent Agilent 89411A European Channel Plans Agilent Agilent 8591C Tektronix 2715 Sunrise Telecom AT2000R Site Log Initials Symbols GL-2 GL-3 GL-4 GL-5 GL-6 D E IN-2 IN-3 IN-4 IN-5 IN-6 IN-7 IN-8
Related manuals
Manual 20 pages 35.92 Kb