Cabletron Systems HSIM-W87 manual Lanview Diagnostic LEDs, Document Conventions

Page 15

Document Conventions

RFC 1213 (MIBII) support for the Interface Table

Cabletron Enterprise MIBs

Refer to the Release Notes included with the host platform for a list of all MIBs supported by the HSIM-W87. For information about how to extract and compile individual MIBs, contact the Cabletron Systems Global Call Center (Section 1.7).

1.4.7LANVIEW Diagnostic LEDs

Cabletron Systems provides a visual diagnostic and monitoring system called LANVIEW. The HSIM-W87 LANVIEW LEDs help you quickly identify status of the device. Chapter 3 provides information on the HSIM-W87 LEDs.

1.5DOCUMENT CONVENTIONS

The following conventions are used throughout this document:

NOTE

Note symbol. Calls the reader’s attention to any item of information that may be of special importance.

!

CAUTION

Caution symbol. Contains information essential to avoid damage to the equipment.

Electrical Hazard Warning symbol. Warns against an action that could result in personal injury or death due to an electrical hazard.

Tip symbol. Conveys helpful hints concerning procedures or

TIP actions.

HSIM-W87 User’s Guide

1-7

Image 15
Contents HSIM-W87 Page HSIM-W87 User’s Guide Industry Canada Notice Cabletron Software Program License HSIM-W87 User’s Guide Contents Contents Using this Manual Chapter IntroductionImportant Notice Overview Imux Features Data Flow in the HSIM-W87Connectivity Inverse Multiplexing Imux Hdlc5 DS1 Alarm Priority QueuingSnmp and MIB Support Document Conventions Lanview Diagnostic LEDsBold type Related DocumentationYour email address Getting HelpHSIM-W87 User’s Guide Unpacking the HSIM-W87 Chapter InstallationInstalling the HSIM-W87 in an Interface Module Installing the HSIM-W87Installing the HSIM-W87 Installing the HSIM-W87 Installing the HSIM-W87 in a Standalone Device HSIM-W87 Setup Connecting the HSIM-W87 to the NetworkLanview Leds ChapterLanview LEDs Local Management Chapter ManagementManagement Network Tools Help CommandsCommand Imux Built-in CommandsImux 1 -ac 1 ExampleWanpq Command wanpqDs1alarm Command ds1alarm Syntax ds1alarmCommand dsx1 Dsx1 Command dsx3Dsx3 Options Special CommandsSyntax DescriptionImux 1 -ac 1 Sample Imux ConfigurationSample Imux Configuration Enabling the Imux Application Chapter Troubleshooting Troubleshooting the HSIM-W87Hardware Troubleshooting Status STS LED is OFF Problems with the Firmware Image Investigating Software Configuration ProblemsHSIM-W87 User’s Guide Appendix a Specifications Physical PropertiesEnvironmental Requirements Regulatory Compliance Appendix B Typical Configuration Appendix B Typical Configuration Appendix C WAN Terms and Acronyms Appendix C WAN Terms and Acronyms WAN Terms and Acronyms HSIM-W87 User’s Guide WAN Terms and Acronyms HSIM-W87 User’s Guide