Cabletron Systems HSIM-W87 manual Built-in Commands, Imux

Page 32

Chapter 4: Management

4.2.2Built-in Commands

The built-in commands listed in this section activate configuration and viewing functions on the HSIM-W87.

imux:

NOTE

Cabletron Systems products that support Inverse Multiplexing (IMUX), such as the HSIM-W87, HSIM-W6, CSX400, and HSIM-W84, must exist on both ends of the WAN link for the IMUX function to work. All bridging and switching functions, such as 802.1D, SecureFast VLAN, and 802.1Q are able to run as normal on the host platform when using the IMUX function on the HSIM-W87.

Syntax: imux <IMUXID>

imux <IMUXID> -[ea da]

imux <IMUXID> -[eg dg] <GROUPID> imux <IMUXID> -[ac dc] <GROUPID>

<INTERFACENUM>

Description: imux is used to combine multiple WAN channels into logical inverse multiplexing (IMUX)groups. Once the IMUX is configured, data will be evenly distributed over all of the logical channels configured.

<IMUXID> - A unique value identifying an element in a sequence of Inverse Multiplexer Applications which belong to an IP host.

<GROUPID> - A unique value identifying an element in a sequence of groups which belong to a WAN Inverse Multiplexer Application.

<INTERFACENUM> - The MIB II ifIndex value used to represent a WAN channel that has an appropriate datalink protocol associated with it.

4-6

HSIM-W87 User’s Guide

Image 32
Contents HSIM-W87 Page HSIM-W87 User’s Guide Industry Canada Notice Cabletron Software Program License HSIM-W87 User’s Guide Contents Contents Important Notice Using this ManualChapter Introduction Overview Imux Connectivity FeaturesData Flow in the HSIM-W87 Hdlc Inverse Multiplexing ImuxSnmp and MIB Support 5 DS1 AlarmPriority Queuing Lanview Diagnostic LEDs Document ConventionsRelated Documentation Bold typeGetting Help Your email addressHSIM-W87 User’s Guide Chapter Installation Unpacking the HSIM-W87Installing the HSIM-W87 Installing the HSIM-W87 in an Interface ModuleInstalling the HSIM-W87 Installing the HSIM-W87 Installing the HSIM-W87 in a Standalone Device Connecting the HSIM-W87 to the Network HSIM-W87 SetupChapter Lanview LedsLanview LEDs Chapter Management Local ManagementManagement Network Tools Commands HelpCommand Built-in Commands ImuxExample Imux 1 -ac 1Command wanpq WanpqCommand ds1alarm Syntax ds1alarm Ds1alarmCommand dsx1 Command dsx3 Dsx1Dsx3 Special Commands SyntaxDescription OptionsSample Imux Configuration Imux 1 -ac 1Sample Imux Configuration Enabling the Imux Application Hardware Troubleshooting Chapter TroubleshootingTroubleshooting the HSIM-W87 Status STS LED is OFF Investigating Software Configuration Problems Problems with the Firmware ImageHSIM-W87 User’s Guide Environmental Requirements Appendix a SpecificationsPhysical Properties Regulatory Compliance Appendix B Typical Configuration Appendix B Typical Configuration Appendix C WAN Terms and Acronyms Appendix C WAN Terms and Acronyms WAN Terms and Acronyms HSIM-W87 User’s Guide WAN Terms and Acronyms HSIM-W87 User’s Guide