Cabletron Systems HSIM-W87 manual Chapter Management, Local Management

Page 27

CHAPTER 4

MANAGEMENT

This chapter describes Local Management and the Network Tools utility. Local Management allows access to statistics screens that apply to the HSIM-W87 through the host platform. Network Tools allows access to a command set from which you can configure and manage the HSIM-W87. This chapter provides the following information:

Overview of Local Managment, Section 4.1

Network Tools used with the HSIM-W87, Section 4.2

Sample IMUX configuration, Section 4.3

4.1LOCAL MANAGEMENT

NOTE

Access to Local Management screens and Network Tools is obtained by using Local Management on the host platform. Refer to the host platform user’s guide to establish a Local Management connection, and for information on the screens.

Make sure that the following requirements have been met before accessing the HSIM-W87 through Local Management:

The HSIM-W87 is properly installed in the host platform.

A management terminal is properly configured and connected, either locally or using Telnet, to the host platform in which the HSIM-W87 resides. Refer to the host platform document for further information.

In order to view the HSIM-W87 statistics screens, you must navigate through a series of Local Management screens via the host platform. Figure 4-1shows a typical hierarchy of screens that you would navigate through in order to reach the HSIM-W87 screens. The lines shown in boldface indicate a typical path used to access the HSIM-W87 statistics screens.

HSIM-W87 User’s Guide

4-1

Image 27
Contents HSIM-W87 Page HSIM-W87 User’s Guide Industry Canada Notice Cabletron Software Program License HSIM-W87 User’s Guide Contents Contents Using this Manual Chapter IntroductionImportant Notice Overview Imux Features Data Flow in the HSIM-W87Connectivity Inverse Multiplexing Imux Hdlc5 DS1 Alarm Priority QueuingSnmp and MIB Support Document Conventions Lanview Diagnostic LEDsBold type Related DocumentationYour email address Getting HelpHSIM-W87 User’s Guide Unpacking the HSIM-W87 Chapter InstallationInstalling the HSIM-W87 in an Interface Module Installing the HSIM-W87Installing the HSIM-W87 Installing the HSIM-W87 Installing the HSIM-W87 in a Standalone Device HSIM-W87 Setup Connecting the HSIM-W87 to the NetworkLanview Leds ChapterLanview LEDs Local Management Chapter ManagementManagement Network Tools Help CommandsCommand Imux Built-in CommandsImux 1 -ac 1 ExampleWanpq Command wanpqDs1alarm Command ds1alarm Syntax ds1alarmCommand dsx1 Dsx1 Command dsx3Dsx3 Options Special CommandsSyntax DescriptionImux 1 -ac 1 Sample Imux ConfigurationSample Imux Configuration Enabling the Imux Application Chapter Troubleshooting Troubleshooting the HSIM-W87Hardware Troubleshooting Status STS LED is OFF Problems with the Firmware Image Investigating Software Configuration ProblemsHSIM-W87 User’s Guide Appendix a Specifications Physical PropertiesEnvironmental Requirements Regulatory Compliance Appendix B Typical Configuration Appendix B Typical Configuration Appendix C WAN Terms and Acronyms Appendix C WAN Terms and Acronyms WAN Terms and Acronyms HSIM-W87 User’s Guide WAN Terms and Acronyms HSIM-W87 User’s Guide