Cabletron Systems MICROMMAC-22T, 42T manual Wall-Mounting the MicroMMAC-T

INSTALLATION

Molly Screw

Anchors

Molly Screws

Bracket Screws

Wall Mounting Bracket

Figure 3-4. Wall-Mounting the MicroMMAC-T

2.Select a wall location within seven feet of a power outlet for the MicroMMAC-T.

WARNING: When drilling pilot holes, any electrical wiring inside the wall may present a potential SHOCK HAZARD. Select a wall location accordingly.

3.Position the MicroMMAC-T against the wall with the network port facing down. Using a pencil, mark the wall location for the four pilot holes.

4.Set the MicroMMAC-T aside and carefully drill four 1/4” pilot holes, (one for each of the Molly screw anchors) and insert the four Molly screw anchors into the holes.

5.Place a screw in each anchor, and tighten until each anchor expands firmly in the wall; then remove the screws completely.

6.Position the MicroMMAC-T on the wall over the anchors and reinstall the four screws to attach the MicroMMAC-T to the wall, as shown in Figure 3-4. Tighten the four screws.

3-4