Philips HC 070 manual Troubleshooting, Problem Remedy, No sound, Distorted sound

Page 8

XP SBC HC 070/00-1 29-08-2001 11:10 Pagina 8

English

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty.

Problem

Remedy

 

 

 

No sound

– Check if the AC/DC adapter is fully inserted into the

 

AC outlet and that its DC connector is properly inserted

 

into the 12 Volt DC input connector located at the rear

 

of the transmitter.

 

– Check if the headphone’s on/off switch is in the on

 

position.

 

– Headphone batteries running low. (See Headphone

 

power supply)

 

– Check if the audio source is switched on.

 

– Volume not adjusted. Adjust the volume on the audio

 

source/ headphone to a higher level.

 

– Make use of the HC072 transmitter. Some transmitters

 

already built into other equipment may not be

 

compatible with the HC075 headphone because of the

 

advanced technologies used in the HC075 headphone.

 

 

 

Distorted sound

– Headphone batteries running low. (See Headphone

 

power supply)

 

– Check the volume on audio source/ headphone is not

 

set at too high a level. Reduce the volume.

 

– Distance from the transmitter is too large. Move closer

 

to the transmitter.

 

– Interference from fluorescent lamps/ other radio

 

sources. Move transmitter or headphone elsewhere.

 

– Make use of the HC072 transmitter. Some transmitters

 

already built into other equipment may not be

 

compatible with the HC075 headphone because of the

 

advanced technologies used in the HC075 headphone.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents HC070 Index 29-08-2001 Congratulations Kit contentsIntroduction General information Controls Installation Transmitter power supplyTransmitter figure Recharging input figure 3 connect IR transmitting LEDs transmit audioHeadphone power supply Headphone battery replacement figureAudio Connections Only use LR03/AAA NiCd batteries preferably PhilipsSwitch on the headphone Audio ConnectionsAudio Connections Basic operationTroubleshooting Problem RemedyNo sound Distorted soundMaintenance SpecificationsContenu de léquipement Introduction Information généraleFélicitations CommandesInstallation Panneau de commandes Casque découte figureVolume ajustez le volume au niveau découte désiré Alimentation de lémetteurEnlevez les coussins auriculaires Connexions AudioAlimentation du casque découte Connexions Audio Connexions AudioMettez le casque découte sous tension Utilisation de baseProblème Solution Dépistage des pannesPas de son Distorsion sonoreSpécifications EntretienIntroducción Información general ¡EnhorabuenaContenido del kit ImportanteMandos InstalaciónFuente de alimentación del transmisor Entrada de recarga figuraInstalación Conexiones de audioFuente de alimentación de los auriculares Cambio de las pilas de los auriculares figuraFuncionamiento básico Conexiones de audioConexiones de audio Resolución de problemas Problema SoluciónNo hay sonido Sonido distorsionadoEspecificaciones ¡Cuidado de sus oídosMantenimiento Distorsión THD Separación de canales 30 dBEinführung Allgemeine Informationen Herzlichen GlückwunschVorteile der aktuellsten HF/FM-Funktechnik von Philips Inhalt des SatzesBedienelementeInstallation Sender-StromversorgungSender Abbildung Bedienfeld Kopfhörer Abbildung IR-SensorenInstallationAudioanschlüsse Kopfhörer-StromversorgungInformationen zum Umweltschutz Entfernen Sie die OhrpolsterAudioanschlüsse AudioanschlüsseGrundlegende Funktionsweise WichtigProblem Abhilfe FehlersucheKein Sound Verzerrter SoundTechnische Daten HörsicherheitInleiding Algemene informatie GefeliciteerdInhoud van de set BelangrijkBedieningselementenInstallatie Voeding van de zenderInstallatieAudioaansluitingen Voeding van de hoofdtelefoonVervangen van de batterijen van de hoofdtelefoon figuur Bij voorkeur PhilipsAudioaansluitingen AudioaansluitingenSchakel de hoofdtelefoon BasisbedieningVerhelpen van storingen Probleem OplossingGeen geluid Vervormd geluidVerhelpen van storingen Technische gegevens Introduzione Informazioni generali CongratulazioniContenuto del kit Se il sistema non deve essere usatoComandiInstallazione Alimentazione della trasmittenteInstallazione Collegamenti audio Alimentazione della cuffiaUsate solo batterie LR03/AAA NiCd preferibilmente Philips Riponete i cuscini auricolari nei loro gusciCollegamenti audio Informazione ecologicaFunzionamento di base Accendete la cuffiaProblema Rimedio Ricerca dei guastiAssenza di suono Suono distortoRicerca dei guasti Caratteristiche Sicurezza dascoltoManutenzione Distorsione THD Separazione dei canali 30 dBConteúdo do kit Introdução Informação geralParabéns Comandos InstalaçãoTransmissor figura Entrada de recargaInstalação Ligações de áudioDe preferência, Philips Desmonte as almofadas auricularesLigações de áudio Funcionamento básicoResolução de problemas Problema SoluçãoNão há som Som com distorçãoEspecificações ManutençãoNiCd de preferência, Philips Limpar a caixa Não utilize quaisquer agentes de limpeza queIntroduktion Generelle informationer Til lykkeSættet indeholder VigtigtBetjeningsanordningerInstallation Transmitterens strømforsyningBatterirummet InstallationAudio-tilslutningerUdskiftning af batterier Hovedtelefonen figur Audio-tilslutninger Audio-tilslutningerTænd for hovedtelefonen Grundlæggende betjeningProblemløsning Problem AfhjælpningIngen lyd Forvrænget lydSpecifikationer Sikkerhed mod høreskaderInledning Allmän information GrattisSatsen innehåll ViktigtReglage Installation Strömmatning för sändarenInstallationLjudanslutningar Strömmatning för hörlurarByte av hörlurarnas batterier figur Använd bara NiCd-batterier av typ LR03/AAA helst PhilipsLjudanslutningar LjudanslutningarKoppla på hörlurarna Anvisningar för enkel användningProblem Åtgärd FelsökningInget ljud Förvrängt ljudSpecifikationer HörselskyddInnledning Generell informasjon GratulererHva settet inneholder ViktigKontrollerInstallasjon Strømforsyning til senderInstallasjonAudiokoplinger Strømforsyning til hodetelefonSkifte ut batteri i hodetelefonen figur Bruk kun LR03/AAA NiCd batterier fortrinnsvis PhilipsVirkemåte AudiokoplingerAudiokoplinger Forvrengt lyd Problem LøsningFeilsøking Feilsøking Spesifikasjoner Vern om hørselenJohdanto Yleistä OnnittelummeVarusteet TärkeääLähettimen virtalähde SäätimetAsennus Kuulokkeen akkujen vaihtaminen kuvaa AsennusAudioliitännätKuulokkeen virtalähde Audioliitännät AudioliitännätKytke kuuloke PerustoimintaVianhaku Ongelma KorjaustoimenpideEi ääntä Säröilevä ääniVianhaku Tekniset tiedot Введение Общая инфоpмацияПоздpавляем Преимущества новейшей беспроволочной системы Philips RF/FMОpганы упpавления Установка Блок питания тpансмиттеpаВxод для заpядки Оpганы упpавления Наушники рис Датчики IRЗвуковые соединения Блок питания наушниковЗамена батаpей наушников рис Снимите подушечки для ушейЗвуковые соединения Звуковые соединенияОсновные опеpации ВажноУстpанение неиспpавностей Пpоблема УстpанениеОтсутствует звук Искажённый звукУход Устpанение неисТеxни. xаpактеpистики Wstęp Informacje ogólne GratulacjeElementy składowe zestawu WażneElementy sterujące Instalowanie Zasilacz nadajnikaNadajnik rysunek 12 Wejście ładowania rysunekPrzyłącza audio Zasilanie słuchawekWymiana akumulatorków słuchawek rysunek Informacje ekologicznePrzyłącza audio Przyłącza audioPodstawowe czynności obsługi Włączyć słuchawkiRozwiązywanie problemów Problem RozwiązanieBrak dźwięku Zniekształcony dźwiękRozwiązywanie probl. Parametry techniczne Bevezetés Általános tudnivalókGratulálunk AlaptartozékokKezelőgombok Üzembe helyezés Rádióadó tápellátásaAudio csatlakozások Fejhallgató tápellátásaFejhallgató telepeinek cseréje 4-es ábra Környezetvédelmi szempontokAlapvetőlépések Audio csatlakozásokAudio csatlakozások Hibakeresés Probléma TeendőNincs hang Torz hangHibakeresés Műszaki jellemzők KarbantartásGiriş Genel bilgi TebriklerPhilips’in en son FR/FM kablosuz teknolojisinin yararları Setin içindekilerKontroller Kurulum İletici güç kaynağıSes Bağlantıları Kulaklık güç kaynağıKulaklık pil değişitirme şekil Sadece LR03/AAA NiCd pilleri kullanın tercihen PhilipsTemel kullanım Ses BağlantılarıSes Bağlantıları Sorun Giderme Sorun ÇözümSes yok Dağılmış sesSorun Giderme Özellikler IR Philips RF/FMIR SBC HC072 IR SBC HC075 Philips SBC CS030/00 12 Volt/200 mA LR03/ AAA NiCdAC/DC PhilipsMm 6,3 mm DC p HC072. O HC075 LR03/AAA NiCd Philips MVrms 1 kHz 12Volt / 200 mA DC ShoneLR03 AAA NiCd 60 dB 1 kHzGarantie für Deutschland Sehr geehrter KundeArrivo Marketing Essener Str Hamburg Philips Info-Center Tel 0180 / 535 67 Fax 0180 / 535 67 100Meet Philips at the Internet

HC 070 specifications

The Philips HC 070 is a versatile and powerful hair clipper designed for achieving precise haircuts with ease. It stands out in the crowded market of grooming tools due to its robust features, innovative technologies, and user-friendly design, making it an essential tool for both professional barbers and home users.

One of the key features of the Philips HC 070 is its powerful and durable motor. This high-performance motor provides consistent cutting performance, allowing users to tackle even thick and coarse hair effortlessly. It ensures that the hair clipper delivers reliable results with each use, saving time and effort during grooming sessions.

Another notable aspect of the HC 070 is its innovative self-sharpening stainless steel blades. These blades are designed to remain sharp over time, ensuring clean and precise cuts without snagging or pulling hair. The self-sharpening technology significantly enhances the clipper's overall longevity, making it a cost-effective grooming solution. The blades are also detachable, enabling easy cleaning and maintenance for optimal hygiene.

The Philips HC 070 offers multiple length settings, providing versatility to achieve various hairstyles. Users can easily adjust the cutting length with the integrated length adjustment system. This feature ensures that everyone, from those desiring a close shave to individuals opting for longer styles, can find their perfect length without the need for additional attachments.

Additionally, the HC 070 features a lightweight and ergonomic design, ensuring comfortable handling during use. The clipper’s design minimizes fatigue, making it easier to maneuver around the head and face, whether performing intricate styles or general trims. The corded design offers an uninterrupted power supply, vital for longer grooming sessions.

Moreover, it is equipped with a convenient cleaning brush, facilitating the easy removal of hair clippings from the blades, further enhancing the user experience. The sleek and modern aesthetic of the clipper also adds to its appeal, making it a stylish addition to any grooming kit.

In summary, the Philips HC 070 combines power, precision, and convenience, making it a top choice for anyone looking to achieve professional-quality haircuts at home or in a salon setting. With features like self-sharpening blades, adjustable length settings, and an ergonomic design, it promises to meet the diverse styling needs of its users effectively.
Top Page Image Contents