Cabletron Systems 2200 manual Unpacking the Device, Installing Options

Page 32

Unpacking the Device

3.1UNPACKING THE DEVICE

Unpack the device as follows:

1.Open the box and remove the packing material protecting the 2E253-49R.

2.Verify the contents of the carton as listed in Table 3-1.

Table 3-1 Contents of 2E253-49R Carton

Item

Quantity

 

 

2E253-49R

1

 

 

Antistatic Wrist Strap

1

 

 

Console Cable Kit

1

 

 

RJ21 Angle Adapter

4

 

 

Rackmount Kit

1

 

 

Strain-Relief Bracket

1

 

 

Manual Accessory Kit

1

 

 

Power Cord

2

 

 

3.Remove the tape seal on the non-conductive bag to remove the 2E253-49R.

4.Perform a visual inspection of the device for any signs of physical damage. Contact Cabletron Systems if there are any signs of damage. Refer to Section 1.2 for details.

3.2INSTALLING OPTIONS

NOTE

Install any optional equipment before proceeding to Section 3.3.

If the 2E253-49R is to be installed with an optional HSIM or VHSIM, refer to the user’s guide of that device for the installation instructions. To install an optional SIMM, refer to Appendix B.

3-2Installation

Page 31 Page 33
Image 32
Page 31 Page 33
Contents 2E253-49R SmartSwitch Installation User’s Guide Page Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Page Page Page Cabletron Systems Limited Program License Agreement Viii Declaration of Conformity Page Contents Troubleshooting Figures Tables Structure of this Guide Using this GuideAbout This Guide Related Documents XviDocument Conventions Document ConventionsPage Introduction OverviewFull Duplex Switched Ethernet ConnectivitySmartTrunk Standard/Full Duplex Auto-NegotiationRuntime IP Address Discovery Port/VLAN Redirect Functions Remote Monitoring RmonBroadcast Suppression Traffic Rate Limiting Flow ControlGarp Switch Operation Switching Options12 802.1 Port Priority ManagementLanview Diagnostic LEDs Optional HSIMs and VHSIMsStandards Compatibility Year 2000 ComplianceGetting Help FTPNetwork Requirements 10BASE-T NetworkPage Installation Installing Options Unpacking the DeviceInstalling the Device Tabletop or Shelf InstallationRackmount Installation Guidelines for the Rackmount InstallationAttaching the Strain-Relief Bracket Rack Mounting the 2E253-49R Connecting Power Installing the Device in a RackConnecting to the Network Redundant Primary AC outlets are On separate circuitsConnection Using the RJ21 Angle Adapter Completing the Installation Troubleshooting Using LanviewPWR No link Is enabled and there is a Troubleshooting Checklist OFF2E253, 2H252, 2H253, and 2H258 Local Using the Reset Button Reset ButtonPage Physical Properties Device SpecificationsSpecifications INPUT/OUTPUT Ports Electrical SpecificationsEnvironmental Requirements COM Port Pinout Assignments Regulatory CompliancePage Optional Installations Mode Switch Bank Settings Required ToolsRemoving the Chassis Cover To remove the chassis cover, proceed as follows Screws Chassis Cover Front Panel Setting the Mode Switches Switch 6 Forced BootPSimm Upgrade Figure B-3shows the location of the Dram Simm connector Locating SIMMsInstalling the Dram Simm SimmInstalling Optional Hsim or Vhsim Interface Modules Figure B-5 Hsim and Vhsim Connector LocationsPage Index NumericsIndex-2
Top Page Image Contents