Cabletron Systems 2200 Electrical Specifications, Environmental Requirements, INPUT/OUTPUT Ports

Page 50

Electrical Speciﬁcations

A.3 ELECTRICAL SPECIFICATIONS

Line Input Range, Volts (V)	100–125 Vac	200–240 Vac
Input Current, Amperes (A)	2.3 A	1.2 A
Frequency, Hertz (Hz)	50/60 Hz	50/60 Hz
Input Power, Volt Amperes (VA)	250 VA	250 VA

A.4 ENVIRONMENTAL REQUIREMENTS

Operating Temperature:	5°C to 40°C (41°F to 104°F)
Storage Temperature:	-30°C to 73°C (-22°F to 164°F)
Operating Relative Humidity:	5% to 90% (non-condensing)

A.5 INPUT/OUTPUT PORTS

Ports 1 through 48 (four RJ 21 connectors):

Interface Slot:

Ethernet (10BASE-T compliant) with RJ21 type connectors. Each connector provides connection for 12 ports.

Slot accepts optional High Speed Interface Module (HSIM) or Very High Speed Interface Module (VHSIM) to provide a variety of cabling connections.

A-2Speciﬁcations

Image 50

Contents 2E253-49R SmartSwitch Installation User’s Guide Page Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Page Page Page Cabletron Systems Limited Program License Agreement Viii Declaration of Conformity Page Contents Troubleshooting Figures Tables Structure of this Guide Using this GuideAbout This Guide Related Documents XviDocument Conventions Document ConventionsPage Introduction OverviewFull Duplex Switched Ethernet ConnectivitySmartTrunk Standard/Full Duplex Auto-NegotiationRuntime IP Address Discovery Port/VLAN Redirect Functions Remote Monitoring RmonBroadcast Suppression Trafﬁc Rate Limiting Flow Control12 802.1 Port Priority Garp Switch OperationSwitching Options ManagementStandards Compatibility Lanview Diagnostic LEDsOptional HSIMs and VHSIMs Year 2000 ComplianceGetting Help FTPNetwork Requirements 10BASE-T NetworkPage Installation Installing Options Unpacking the DeviceInstalling the Device Tabletop or Shelf InstallationRackmount Installation Guidelines for the Rackmount InstallationAttaching the Strain-Relief Bracket Rack Mounting the 2E253-49R Connecting Power Installing the Device in a RackConnecting to the Network Redundant Primary AC outlets are On separate circuitsConnection Using the RJ21 Angle Adapter Completing the Installation Troubleshooting Using LanviewPWR No link Is enabled and there is a Troubleshooting Checklist OFF2E253, 2H252, 2H253, and 2H258 Local Using the Reset Button Reset ButtonPage Physical Properties Device SpecificationsSpeciﬁcations INPUT/OUTPUT Ports Electrical SpecificationsEnvironmental Requirements COM Port Pinout Assignments Regulatory CompliancePage Optional Installations Mode Switch Bank Settings Required ToolsRemoving the Chassis Cover To remove the chassis cover, proceed as follows Screws Chassis Cover Front Panel Setting the Mode Switches Switch 6 Forced BootPSimm Upgrade Figure B-3shows the location of the Dram Simm connector Locating SIMMsInstalling the Dram Simm SimmInstalling Optional Hsim or Vhsim Interface Modules Figure B-5 Hsim and Vhsim Connector LocationsPage Index NumericsIndex-2