Brocade Communications Systems 53-1002599-01 manual Connecting network devices, Connectors

3 Connecting network devices

Deleting an IP address

Enter a command similar to the following to delete an IP address.

Brocade(config-if-1/1/1)# no ip address 1.1.2.1

This command deletes IP address 1.1.2.1. You do not need to enter the subnet mask.

To delete all IP addresses from an interface, enter the following command:

Brocade(config-if-1/1/1)# no ip address *

Syntax: no ip address ip-addr *

Connecting network devices

Brocade devices support connections to other vendors’ routers, switches, and hubs, as well other Brocade devices.

Connectors

For port pinouts, refer to “Pinouts and signalling” on page 50.

Connecting a network device to a fiber port

For direct attachment from the device to a Gbps NIC, switch, or router, using a fiber optic transceiver, you will need fiber cabling with an LC connector.

For information about transceivers supported on ICX 6650 devices, refer to the following Brocade website:

http://www.myBrocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_ DS.pdf

To connect the device to another network device using a fiber port, you must do the following tasks:

•Install a fiber optic transceiver (SFP, or SFP+)

•Cable the fiber optic transceiver

The following sections describe these tasks.

26	Brocade ICX 6650 Hardware Installation Guide
	53-1002599-01