Configuring IP addresses | 3 |
Syntax: [no] ip address
or
Syntax: [no] ip address
Syntax: ip
Devices running Layer 3 software
Before attaching equipment to a Brocade ICX 6650 switch, you must assign an interface IP address to the subnet on which the router will be located. You must use the serial connection to assign the first IP address. For subsequent addresses, you also can use the CLI through Telnet or the Web management interface.
By default, you can configure up to 24 IP addresses on each port, virtual interface, and loopback interface. You can increase this amount to up to 64 IP subnet addresses per port by increasing the size of the
The following procedure shows how to add an IP address and mask to a router port.
1. At the opening CLI prompt, enter enable.
Brocade> enable
2.Enter the following command at the CLI Privileged EXEC level prompt, then press Enter. This command erases the factory test configuration if still present:
Brocade# erase
CAUTION
Use the erase
3. Access the configuration level of the CLI by entering the following command:
Brocade# configure terminalPrivileged EXEC Level
Brocade(config)# | Global CONFIG Level |
4. Configure the IP addresses and mask addresses for the interfaces on the router.
Brocade(config)# int e 1/1/1
NOTE
You can use the syntax ip address
Syntax: enable [password]
Syntax: configure terminal
Syntax: [no] ip address
or
Brocade ICX 6650 Hardware Installation Guide | 23 |
|