Extron electronic MVX VGA A manual Creating a configuration

PRELIMINARY

Operation, cont’d

Creating a configuration

The current configuration can be changed using the front panel buttons. Change the current configuration as follows:

1.	Press the Esc button to clear any input LEDs, output LEDs, or control LEDs
	that are lit.
2.	Select to configure video, audio, or both by pressing the RGBHV button
	and/or Audio button.
3.	Select the desired input and output(s) by pressing the input and output
	buttons.
	To indicate potential ties, output LEDs blink when an output is selected but
	not tied to the input.
	To indicate current ties, output LEDs light steadily when an input is tied to
	the output.
	To clear unwanted outputs, press and release the output buttons associated
	with the lit LEDs. To indicate potential unties, output LEDs blink when an
	output is deselected but not untied from the input.
4.	Press and release the Enter button to accept the new tie or to break an existing
	tie.
5.	Repeat steps 1 through 4 to create additional ties until the desired
	configuration is complete.

N• Only one video input and one audio input can be tied to an output.

•If a tie is made between an input and an output, and the selected output was previously tied to another input, the older tie is broken in favor of the newer tie.

•To indicate current ties, output LEDs light when an input is selected. To clear unwanted outputs, press and release the associated output buttons.

•If, when you are configuring video and audio ties, the Audio LED blinks and the RGBHV LED is on after you select an input or output, the LEDs indicate audio breakaway, meaning that the audio ties are not the same as the video ties for that input.

•If an input with no tie is selected, only that input’s LED lights.

•When the RGBHV and Audio LEDs are on, if an input with an audio tie but no video tie is selected, the input’s LED lights and the Audio LED and the output LED(s) blink.

•As each output is selected, the associated output LED blinks to indicate a tentative tie. LEDs for output(s) that were already tied to the input light steadily. Outputs that are already tied can be left on, along with new blinking selections, or toggled off by pressing the associated output button.

3-8 MVX VGA A Matrix Switchers • Operation