Extron electronic MVX VGA A manual Matrix Software, cont’d

PRELIMINARY

Matrix Software, cont’d

2.	Choose either the comm port that is connected to the switcher’s serial port or
	Emulate.

NAlthough IP [LAN] is available for selection, the switcher does not have an Ethernet port. Do not select IP [LAN].

If you selected a comm port, check the baud rate displayed in the comm port selection window. If you need to change the baud rate, click on the Baud button and double-click on the desired baud rate.

Available rates are 9600, 19200, 38400, and 115200. The default is 9600.

NSee “Selecting the rear panel Remote port protocol and baud rate” in chapter 3, “Operation”, on page 3-38, to identify the selected baud rate from the front panel.

Click OK and proceed to step 3.

If you selected Emulate, click OK and see “Using Emulation mode” on page 5-13.

3. The Extron Matrix Switcher Control Program window (figure 5-4 and figure 5-5) appears. The window displays the current configuration of the attached matrix.

Figure 5-4 — Extron Matrix Switcher Control Program window (blank)

5-4 MVX VGA A Matrix Switchers • Matrix Software