Extron electronic MTPX PLUS 3232, MTPX PLUS 816, MTPX PLUS 168, MTPX PLUS 1616 Front Panel, Power

Installation, cont’d

k	Ethernet port — If desired, connect a network WAN
	or LAN hub, a control system, or a computer to the
	Ethernet RJ-45 port.

•Network connection — Wire as a patch (straight) cable.

•Computer or control system connection — Wire the interface cable as a crossover cable.

NThe factory default IP address is 192.168.254.254.

Power

lPowersource.connector — Plug the switcher into a grounded AC

Front Panel

CONTROLI/O

ENTER PRESET VIEW ESC VIDEO AUDIO

CONFIG

MTPX PLUS SERIES

MTP MATRIX SWITCHER

13

Figure 2-8 — Configuration port, most models

mConfiguration port (switchers other than the MTPX Plus 128) —

If desired, connect a control system or computer to the front panel Configuration (RS-232) port. Use an optional 9-pin D to 2.5 mm mini jack TRS RS-232 cable, part #70-335-01.

	I	1	2	3	4
	N
	P
	U
	T
CONFIG	O	1	2	3	4
	U
	PT
	U
	T

14

Figure 2-9 — Configuration port, MTPX Plus 128

nConfiguration port (MTPX Plus 128 only) — If desired, connect a control system or computer to the front panel Configuration port, a mini USB B port.

2-6 MTPX Plus Series • Installlation

MTPX Plus Series Matrix Switcher

Chapter3Three

Front Panel Operation

Creating a Tie

Saving or Recalling a Preset

Setting the Front Panel Locks (Executive Modes)

Defining the Audio/RS-232 Wire Pair and Configuring the Remote Port

Viewing and Adjusting the Audio Level

Viewing Ties and Muting Outputs

Video Adjustments

Refer also to the MTPX Plus User’s Manual at www.extron.com.