Command | ASCII command | Response | Additional description |
| (host to switcher) | (switcher to host) |
|
Refer also to the MTPX Plus User’s Manual at | MTPX Plus Series • Remote Control |
and www. | |
extron |
|
IP setup
Set IP address Read IP address Set subnet mask Read subnet mask Set gateway IP address Read gateway IP address Set DHCP on or off Read DHCP on/off status Set verbose mode
Read verbose mode
Configure current port timeout Read current port timeout Configure global IP port timeout Read global IP port timeout
EX2^CI} IpiX2^]
ECI} X2^]
EX2^CS} IpsX2^]
ECS} X2^]
EX2^CG} IpgX2^]
ECG} X2^]
EX2&DH} IdhX2&]
EDH} X2&]
EX2*CV} VrbX2*]
ECV} X2*]
E0*X2(TC} Pti0*X2(]
E0TC} X2(]
E1*X2(TC} Pti1*X2(]
E1TC} X2(]
Optimizing .com. |
the Video |
N X2^= IP address | nnn.nnn.nnn.nnn | |
X2&= DHCP | 0 | =1 off, 1 = on |
X2*= Verbose mode | 0 | = clear/none (default for Telnet connection) |
| 1 | = verbose mode (default for |
| 2 | = tagged responses for queries |
X2(= Port timeout interval | 3 | = verbose mode and tagged for queries |
1 | (= 10 seconds) - 65000 (default is 30 = 300 seconds = 5 minutes) | |
Remote Control and Optimizing the Video, cont’d