Extron electronic MTPX PLUS 3216, MTPX PLUS 816 setup guide Front Panel Operation, Creating a Tie

Front Panel Operation

The key shown at right applies	= lit,	= blinking,	= unlit
to all drawings in this chapter.

Creating a Tie

A "tie" is an input-to-output connection.

A "set of ties" is an input tied to two or more outputs. (An output can never be tied to more than one input.)

A "configuration" is one or more ties, one or more sets of ties, or a combination.

1.	Press and release the Esc button to clear any input button,
	output button, or control button indicators that may be lit.
2.	Press and release the Video and/or Audio I/O button(s) to
	select or deselect video and/or audio as desired.
		I / O
	Green when selected			Red when selected
		VIDEO	AUDIO
	Off when deselected			Off when deselected

NAudio (RS-232) or video can be broken away (tied by itself) by selecting only the Video button or only the Audio button.

3.	Press and release the desired input button.
	The button lights to indicate the selection.
		5
4.	Press and release the desired output buttons.
	Amber indicates video and audio tie.
	Green indicates video only tie.
	Red indicates audio only tie.
	3	4	8	ENTER
				Green indicates the
				need to confirm the
				change.
5.	Press and release the Enter button. All button indicators
	turn off.

= lit, = blinking,

3-2 MTPX Plus Series • Front Panel Operation

Saving or Recalling a Preset

A "preset" is a configuration that has been stored.

1. Save a preset — Press and hold the Preset button until it flashes.

Recall a preset — Press and release the Preset button.

Save a	PRESET	2 seconds	PRESET
preset
	Press and hold.		Preset button blinks.
Recall a	PRESET		PRESET
preset
	Press and release.		Preset button lights.

All input and output buttons with assigned presets light red.

The configuration data at assigned preset locations will be overwritten.

					INPUTS
1	2	3	4	5	6

2.	Press and release the desired input or output button.
			The button blinks red to indicate that
			this preset is selected to save or recall.
					The Enter button blinks
		1		ENTER
					red to indicate the need to
					activate the save or recall.
3.	Press and release the Enter button.

= lit, = blinking,

MTPX Plus Series • Front Panel Operation 3-3

Refer also to the MTPX Plus User’s Manual at www.extron.com. Refer also to the MTPX Plus User’s Manual at www.extron.com.