Extron electronic PS 124, cont’d Connections, Input power using the IEC power cord

Page 10

PS 124, cont’d

Connections

Input power — using the IEC power cord

Use the included IEC power cord to connect the PS 124 to a 100 VAC to 240 VAC, 50-60 Hz power source.

WThe circuit breaker used for this connection should be rated 20 amps maximum.

Input power — using the Flexible Conduit Adapter Kit

The optional Flexible Conduit Adapter Kit, part # 70-228-02, provides a convenient means to replace the IEC power cord with conduit when required by local codes.

The kit consists of:

•One EMT adaptor plate

•One 6-foot long electrical conduit

•Three 7.5 feet, 18-gauge spade connector power wires

•One UL Listed zip tie wrap

•Three auxiliary crimp style spade connectors designed for 14- to 16-gauge wires

NExtron recommends using a crimp tool such as Molex part #19285-0008to terminate the spade connectors.

Make certain the PS 124 and all connected devices are turned off and disconnected from the power source before beginning.

WThe circuit breaker used for this connection should be rated 20 amps maximum.

WFor permanently connected equipment there must be a readily accessible disconnect device incorporated in the building installation wiring.

WInstallation and service must be performed by a qualified electrician only.

4 PS 124 12 VDC, 4 Amp Power Supply • Installation Manual

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Installation Manual 12 VDC, 4 Amp Power SupplyPrecautions FCC Class B Notice Vcci Class B notice for ITE productsPage Table of Contents Table of Contents, cont’d Power status LEDs These front and rear panel LEDs indicate Front and Rear Panel FeaturesLED indicators IntroductionInput Power PS 124, cont’d12VDC 4A Power Supply PS 124 supports up to eight power supply outputs. ForConnectors, see Output power wiring the DC output DC OutputsInput power using the Flexible Conduit Adapter Kit Input power using the IEC power cordPS 124, cont’d Connections Installing the flexible conduit cable This unit must be installed in accordance with the NationalUL guidelines Unscrew the ground wire nut on the bottom of the PS Removing the top coverInstall the EMT adapter plate into the opening From the conduit kit, thread the 18-gauge power wiresSee out of the enclosure Output power wiring the DC output connectors PS 124 can supply 12 VDC to multiple devices usingInstalling the PS UL rack mounting guidelinesRack mounting Rack mounting the PSPS 124 12 VDC, 4 Amp Power Supply Installation Manual Under-desk mountingPMK Above-projector mountingTo mount the PS 124 onto the PMK 350 bracket Pass the legs through the holes in the L-shaped bracket 14 PS 124 12 VDC, 4 Amp Power Supply Installation Manual Specifications GeneralIncluded Parts AccessoriesAccessories Part number Included parts Part numberExtron’s Warranty USA, Canada, South America Central AmericaExtron Electronics. All rights reserved
Top Page Image Contents