Extron electronic PS 124 FCC Class B Notice, Vcci Class B notice for ITE products

Page 3
(See the product’s specifications to determine

•

•



 



•

 

•



•



•

 

•

 

•



 

•



•



 

•

 

FCC Class B Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

NThis unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the unit to ensure compliance.

VCCI Class B notice for ITE products

whether this class applies.)

この装置は、情報処理装置等電波障害自主規制協議会(VCCI)の基準に基づくクラスB情報技術装置で す。この装置は、 家庭環境で使用することを目的としていますが、この装置がラジオやテレ ビジョン受信機に近接して使用されると、受信

障害を引き起こすことがあります。

取扱説明書に従って正しい取り扱いをして下さい。

English translation: “This is a Class B product based on the standard of Voluntary Control Council for Interference from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.”

Image 3
Contents 12 VDC, 4 Amp Power Supply Installation ManualPrecautions Vcci Class B notice for ITE products FCC Class B NoticePage Table of Contents Table of Contents, cont’d Introduction Front and Rear Panel FeaturesLED indicators Power status LEDs These front and rear panel LEDs indicatePS 124, cont’d Input PowerDC Outputs PS 124 supports up to eight power supply outputs. ForConnectors, see Output power wiring the DC output 12VDC 4A Power SupplyInput power using the IEC power cord Input power using the Flexible Conduit Adapter KitPS 124, cont’d Connections This unit must be installed in accordance with the National Installing the flexible conduit cableUL guidelines Removing the top cover Unscrew the ground wire nut on the bottom of the PSFrom the conduit kit, thread the 18-gauge power wires Install the EMT adapter plate into the openingSee out of the enclosure PS 124 can supply 12 VDC to multiple devices using Output power wiring the DC output connectorsUL rack mounting guidelines Installing the PSRack mounting the PS Rack mountingUnder-desk mounting PS 124 12 VDC, 4 Amp Power Supply Installation ManualAbove-projector mounting PMKTo mount the PS 124 onto the PMK 350 bracket Pass the legs through the holes in the L-shaped bracket 14 PS 124 12 VDC, 4 Amp Power Supply Installation Manual General SpecificationsIncluded parts Part number AccessoriesAccessories Part number Included PartsUSA, Canada, South America Central America Extron’s WarrantyExtron Electronics. All rights reserved