Extron electronic PS 124 installation manual Above-projector mounting, Pmk

Page 18

PS 124, cont’d

Above-projector mounting

PMK 350

The PMK 350, (part #70-563-03), is an above-projector mounting kit that attaches to a 1" to 2" diameter projector mounting pole (figure 11). It can hold multiple devices in a variety of sizes.

NThese instructions are for the PMK 350. If another above‑projector mounting is used, follow the installation instructions for that kit.

Extron

IPL T S2

Ethernet Control

InterfaceExtron

PS 124

Rear Plate	12 VDC 4 A
	Power Supply

Extron PMK 350

Multi-product Projector Mounting Kit

U-bolt

A 122

MP

Extron

MPA 122

Mini Power Amplifier

Cover Sheet

	124
P/S	Y
SUPPL
WER
4A PO

12 VDC

Front Plate

Figure 11 — Projector mounting the PS 124

To mount the PS 124 onto the PMK 350 bracket:

1. Remove the front and rear plates from the PMK 350 (figure 11). Retain the screws to reattach the plates.

2. If necessary, remove the feet from the bottom of the PS 124.

3. Secure the unit to one side of the mounting tray, using two of the 4-40 x 3/16" screws in opposite (diagonal) corners.

4. Place the PMK 350 around the projector ceiling mounting pole (figure 11, above).

12 PS 124 12 VDC, 4 Amp Power Supply • Installation Manual

Image 18

Contents Installation Manual 12 VDC, 4 Amp Power SupplyPrecautions FCC Class B Notice Vcci Class B notice for ITE productsPage Table of Contents Table of Contents, cont’d Power status LEDs These front and rear panel LEDs indicate Front and Rear Panel FeaturesLED indicators IntroductionInput Power PS 124, cont’d12VDC 4A Power Supply PS 124 supports up to eight power supply outputs. ForConnectors, see Output power wiring the DC output DC OutputsInput power using the IEC power cord Input power using the Flexible Conduit Adapter KitPS 124, cont’d Connections This unit must be installed in accordance with the National Installing the flexible conduit cableUL guidelines Unscrew the ground wire nut on the bottom of the PS Removing the top coverFrom the conduit kit, thread the 18-gauge power wires Install the EMT adapter plate into the openingSee out of the enclosure Output power wiring the DC output connectors PS 124 can supply 12 VDC to multiple devices usingInstalling the PS UL rack mounting guidelinesRack mounting Rack mounting the PSPS 124 12 VDC, 4 Amp Power Supply Installation Manual Under-desk mountingAbove-projector mounting PMKTo mount the PS 124 onto the PMK 350 bracket Pass the legs through the holes in the L-shaped bracket 14 PS 124 12 VDC, 4 Amp Power Supply Installation Manual Specifications GeneralIncluded Parts AccessoriesAccessories Part number Included parts Part numberExtron’s Warranty USA, Canada, South America Central AmericaExtron Electronics. All rights reserved