Extron electronic PS 124 installation manual Under-desk mounting

Page 17

Under-desk mounting

In addition to using the PS 124 power supply on a rack or projector, it can also be mounted under furniture (such as a desk) using the MBU 125 Under-Desk Mounting Kit (part

#70-077-01). To mount the PS 124 under a desk or other furniture, follow these steps:

1. Attach the mounting brackets to the power supply with the provided machine screws (figure 10).

2. Hold the power supply with the attached brackets against the underside of the furniture. Mark the location of the screw holes of the bracket on the mounting surface.

3. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the mounting surface at the marked screw locations.

4. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4" of the screw head protrudes.

Figure 10 — Under-desk mounting the PS 124

5. Align the mounting screws with the slots in the brackets and place the power supply against the surface, with the screws through the bracket slots.

6. Slide the unit slightly forward or back, then tighten all four screws to secure it in place.

PS 124 12 VDC, 4 Amp Power Supply • Installation Manual

11

Page 16 Page 18
Image 17
Page 16 Page 18
Contents 12 VDC, 4 Amp Power Supply Installation ManualPrecautions Vcci Class B notice for ITE products FCC Class B NoticePage Table of Contents Table of Contents, cont’d LED indicators Front and Rear Panel FeaturesPower status LEDs These front and rear panel LEDs indicate IntroductionPS 124, cont’d Input PowerConnectors, see Output power wiring the DC output PS 124 supports up to eight power supply outputs. For12VDC 4A Power Supply DC OutputsPS 124, cont’d Connections Input power using the IEC power cordInput power using the Flexible Conduit Adapter Kit UL guidelines This unit must be installed in accordance with the NationalInstalling the flexible conduit cable Removing the top cover Unscrew the ground wire nut on the bottom of the PSSee out of the enclosure From the conduit kit, thread the 18-gauge power wiresInstall the EMT adapter plate into the opening PS 124 can supply 12 VDC to multiple devices using Output power wiring the DC output connectorsUL rack mounting guidelines Installing the PSRack mounting the PS Rack mountingUnder-desk mounting PS 124 12 VDC, 4 Amp Power Supply Installation ManualTo mount the PS 124 onto the PMK 350 bracket Above-projector mountingPMK Pass the legs through the holes in the L-shaped bracket 14 PS 124 12 VDC, 4 Amp Power Supply Installation Manual General SpecificationsAccessories Part number AccessoriesIncluded Parts Included parts Part numberUSA, Canada, South America Central America Extron’s WarrantyExtron Electronics. All rights reserved
Top Page Image Contents