Cables to Go AVS815 Infra-red remote-control unit for the cable tuner, General, Control elements

6. The infra-red remote-control unit for the cable tuner

General

You need the RC 815 remote-control unit in order to be able to control the cable tuner integrated into the AVS 850 Power Transmitter. The basic code "0000” is set on the remote-control unit when it is delivered. This code can be changed, e.g. if two parties in one building want to use the AVS 815 Power Transmitter in parallel (see more about this under Point 6.4).

Control elements

TX Power:	for switching the 2.4 GHz wireless transmitter on and off
Power:	for switching the AVS 850 on and off
0-9,+100:	direct TV channel selection
CH:	for paging up and down through the cable-TV channels
CH RTN:	for switching back to the channel last selected.
TV/CATV:	for switching between TV channels and cable
	TV channels.
TV/VIDEO:	for switching between cable TV and video input
SCAN:	automatic search tuning for TV and cable TV transmitters
	(to start the automatic search tuning, press "SCAN” twice)
CH+/-:	Add or delete cable TV channels.
	To delete a channel, select the one you want to delete,
	such as no. 30, and press "CH+/-”. "-30 CANCEL” will
	appear in the screen. Next time you page through the
	channel, no. 30 will no longer appear.
	To add a channel (again), select it directly, e.g. select no.
	30 by pressing 3+0. Press "CH+”. "-30 ADD” will appear
	in the display. Next time you page through the channel,
	no. 30 will be there.
TXA-TXD:	for setting the 2.4 GHz transmission channel. This setting
	must be the same as the channel in the AVS 840 Power
	Transmitter. TXA=Channel 1, TXB= Channel 2,
	TXC= Channel 3, TXD= Channel 4.
SET:	for setting the code (see Point 6.2).
VOL:	no function
FUNC:	for setting the code (see Point 6.2).
MTS:	no function
MUTE:	no function
RECALL:	shows the current mode in the TV channel and wireless
	channel (e.g. TXA) in the television screen.

28