Cables to Go AVS815 manual Safety instructions, General description, Correct and proper use

Page 4

1. Safety instructions

IMPORTANT

If the system is handled incorrectly there is a risk of injury from electric shock. The following instructions must be followed, in order to avoid any risk of injury or damage, and the operating instructions must also be adhered to.

-It is never allowed to open the plug-in mains adapter

-Only a properly qualified technician is allowed to check and inspect the system.

-The system is only ever to be operated in dry, indoor rooms.

-Avoid high atmospheric humidity and extreme ambient temperatures

-Should any fault occur in the power supply the system should be taken out of operation at once. Never replace defective parts with anything other than original spare parts.

-If there is any danger of a thunderstorm, it is a good precaution to separate the system from the mains network in order to protect it from lightning. The same applies if the system is to be out of action for any length of time.

-Power must be supplied at the correct rating at all times. This applies in particular to the operating voltage in the system and the mains adapter.

-If there is ever any malfunction, the dealer from whom the system was acquired must be asked to send it back to the manufacturer for inspection.

2. General description

Correct and proper use

The TV AVS 815 Power Transmitter is designed for use in dry, indoor rooms. The power supply is provided by the mains adapter enclosed with the Transmitter. Please only ever use this mains adapter.

It is not allowed to alter or modify any part of the system.

The unit is registered as a device that does not cause or suffer radio- frequency interference, it is CE-approved, and it conforms with the Low Voltage Directory.

The safety and installation instructions must be observed.

There shall be no guarantee cover against damage resulting from any failure to observe these operating instructions, and no legal liability for any resultant consequential damage.

General functions

With the TV AVS 815 Power Transmitter you can transmit cable television signals, and signals from other video equipment such as VCR, SAT- receivers, and video cameras by radio.

The audio and video signals are transmitted in the 2.4 GHz range by the AVS 815 Power Transmitter to the AVS 840 Power Receiver. The maximum line-of-sight range is 300 metres.

The cable tuner integrated into the AVS 850 Power Transmitter is controlled by the Power Receiver with the enclosed RC 815 infra-red remote control. If you point the remote-control unit in the direction of the infra-red window on the AVS 840 receiver, the infra-red signals from this remote-control unit will be converted into radio signals which will in turn be transmitted in the 433 MHz range to the AVS 850 Power Transmitter. Inside the AVS 850, the radio signals are converted back into infra-red signals and passed on to the integral cable tuner.

22

Image 4
Contents Cable Sender Power sender TV AVS815 Thank you very much Contents Safety instructions General descriptionCorrect and proper use General functionsTransmissions Items included AVS 850 Power TransmitterControl elements Channel switch TV channel selection switchMode switch On / Off switchAVS 840 Power Receiver Connecting socket for 9 V mains adapterRear side V Cinch output socketsChannel and switch settings Use as receiver without channel switchingChannel switch rear side Use as receiver with channel switchingGeneral Infra-red remote-control unit for the cable tunerControl elements Connecting the AVS 850 Power Transmitter Bringing into operationConnecting Connecting the AVS 850 Power ReceiverStarting up Page Changing the coding of the RC 815 remote-control unit Settings on the cable tunerPlease proceed as follows Page Fine-tuning the TV AVS 815 Power Transmitter Operating possibilitiesExample 1 Power Transmitter to 3 Power Receivers Problem Remedy Rectifying a malfunctionPoor transmission quality No transmissionTechnical data UHF