Cables to Go AVS815 manual Thank you very much

Page 2

Thank you very much.

You have acquired an electronic system of a very high technical standard. With the TV AVS 815 Power Transmitter you can transmit colour images with stereo sound through walls and ceilings.

The greatest possible care is necessary for bringing it into operations, and that means studying every point in these operating instructions.

Please read these operating instructions even if a third party has already installed the system because they contain important information and the basic principles of operation.

We would not expect any problems to arise with the system, but if any should occur please inform the dealer from whom you acquired this device.

Please keep this instructions ready to hand whenever you may need to consult them.

Image 2

Contents Cable Sender Power sender TV AVS815 Thank you very much Contents Correct and proper use Safety instructionsGeneral description General functionsTransmissions Control elements AVS 850 Power TransmitterItems included Mode switch Channel switchTV channel selection switch On / Off switchRear side AVS 840 Power ReceiverConnecting socket for 9 V mains adapter V Cinch output socketsChannel switch rear side Channel and switch settingsUse as receiver without channel switching Use as receiver with channel switchingControl elements Infra-red remote-control unit for the cable tunerGeneral Connecting the AVS 850 Power Transmitter Bringing into operationStarting up Connecting the AVS 850 Power ReceiverConnecting Page Please proceed as follows Settings on the cable tunerChanging the coding of the RC 815 remote-control unit Page Fine-tuning the TV AVS 815 Power Transmitter Operating possibilitiesExample 1 Power Transmitter to 3 Power Receivers Poor transmission quality Problem RemedyRectifying a malfunction No transmissionTechnical data UHF