Settings on the cable tuner | Cables to Go AVS815 guide

7. Starting up

7.3 Settings on the cable tuner

The settings on the cable tuner are made with the RC 815 infra-red remote-control unit from the place where the AVS 840 Power Receiver is set up.

Note: the TV AVS 815 Power Transmitter has two separate television programme memories, one for TV channels and the other for cable TV channels. You have to do a separate search-tuning scan for each level.

1.	Switch on the television set to which the AVS 840 is connected and
	select the video input (AV).
2.	Switch on the AVS 850 Power Transmitter and the AVS 840 Power
	Receiver.
3.	The television set will display "RF ID OOO”.
4.	Press the "Power” button to switch on the AVS 850 Power
	Transmitter.
5.	Select the "TV/CATV” button with the level "TV”.
6.	Press the "SCAN” button, and the TV will display "PROGRAMME
	PRESS SCAN AGAIN”, so press "SCAN” again (within 2 seconds).
7.	The automatic search tuning scan (for terrestrial TV transmitters) will
	run for the TV level (it takes about 1 minute).
8.	Select the level "CATV” with the "TV/CATV” button.
9.	Press the "SCAN” button, and the TV will display "PROGRAMME
	PRESS SCAN AGAIN”, so press "SCAN” again (within 2 seconds).
10.	The automatic search tuning scan for the CATV level (cable TV) will
	run.
11. Finished – with the channel section button "CH” you can now page
	through all the channels that have been found.
12.	To delete channels or to put them back, press the "CH+/-” button
	(see description of RC 815, Point 5).

7.4Changing the coding of the RC 815 remote-control unit

Note: it is only necessary to change the code of the RC 815 remote- control unit if another TV AVS 815 Power Transmitter is being operated in your immediate neighbourhood (within about 300 metres).

The basic setting for the code is "000”. To operate the TV AVS 815 Power Transmitter, you need the RC 815 infra-red remote-control unit included with the system.

To avoid switching your neighbour’s Power Transmitter TV on and off, you can set a code on the RC 815 remote-control unit and at the AVS 850 Power Transmitter.

Please proceed as follows:

1.Connect the AVS 840 Power Receiver to the television set to which the cable signal is to be sent (see Point 6.2).

2.Take the AVS 850 Power Transmitter, place it next to the AVS 840 Power Receiver, and connect only the mains adapter.

3.Take the RC 815 remote-control unit and press the buttons "FUNC” and "SET” simultaneously for about 2 seconds. (The red LED will flicker when you let go of them).

4.Use the number keys (0 to 9) to enter a three-digit code number. Any number is

13. The "TV/CATV” button can be used to select either TV or cable TV.

available between 000 and 255.

RC 815 infra-red

remote-control unit