Cables to Go AVS815 manual Bringing into operation, Connecting the AVS 850 Power Transmitter

Page 11

7. Bringing into operation

7.1 Connecting the AVS 850 Power Transmitter

Scart cable

H

 

 

 

(accessory)

 

 

 

 

 

 

 

Adapter

 

 

 

B

B

 

 

 

 

Scart cable "out”

G

 

K

 

 

 

 

Radio TV

 

TV

 

C

 

I AV-in

Ant.-in

D

Co-axial cable

A

E Co-axial cable

 

 

 

 

 

out AV-out VCR/SAT

 

 

 

F

 

 

 

 

1.Insert the cable branch plug "A” into the TV cable socket.

2.Insert the adapter "B” into the aerial socket of the AVS 850.

3.Connect the cable branch plug "A” and the aerial input "B” of the AVS 850 with the enclosed co-axial cable "C”, using the adapter "B”.

4.Connect the cable branch plug "A” and the aerial input "D” of the TV set with the existing co-axial cable "E” (not included with this system).

5.Connect the video output "F” of the video recorder or SAT receiver with the video input "G” of the AVS 850, using the cinch/scart cable labelled "out”.

6.Connect the video output "H” of the AVS 850 with the video input "I” of the television set (cable not included with this system).

Note: Points 5 and 6 are not necessary if the signal from the video recorder is not to be transmitted.

Note: If you use a cinch cable for the connection (accessory), note when connecting the unit that the colour of the plug has to match the colour of the socket on the unit. If they are different, please note the following: the yellow plug carries the video signal and must be inserted into the "video” socket, the red one goes into "audio right”, and the white one into "audio left”.

7.Insert the mains adapter plug into a 230 V mains socket, and the unit plug into the socket provided. Never use any other mains adapter than this one.

8.Switch the AVS 850 on with the "POWER” switch (an LED lights up). Place the AVS 850 video transmitter in a favourable position such as on top of the television set.

9.Insert the RX 579 infra-red module into the "IR-Extender” socket provided and glue the infra-red diode onto the eye of the unit it is to control (see Point 3).

29

Image 11
Contents Cable Sender Power sender TV AVS815 Thank you very much Contents General functions Safety instructionsGeneral description Correct and proper useTransmissions Control elements AVS 850 Power TransmitterItems included On / Off switch Channel switchTV channel selection switch Mode switchV Cinch output sockets AVS 840 Power ReceiverConnecting socket for 9 V mains adapter Rear sideUse as receiver with channel switching Channel and switch settingsUse as receiver without channel switching Channel switch rear sideControl elements Infra-red remote-control unit for the cable tunerGeneral Bringing into operation Connecting the AVS 850 Power TransmitterStarting up Connecting the AVS 850 Power ReceiverConnecting Page Please proceed as follows Settings on the cable tunerChanging the coding of the RC 815 remote-control unit Page Operating possibilities Fine-tuning the TV AVS 815 Power TransmitterExample 1 Power Transmitter to 3 Power Receivers No transmission Problem RemedyRectifying a malfunction Poor transmission qualityUHF Technical data