IDE Channel 2/3/4/5 Master
IDE HDD 
Extended IDE Drive SATA devices setup. You can use one of two methods:
Auto | Allows BIOS to automatically detect SATA IDE devices during POST. |
| (Default value) |
None | Select this if no SATA IDE devices are used and the system will skip the |
| automatic detection step and allow for faster system start up. |
Access Mode | Use this to set the access mode for the hard drive. The two options are: |
| Large/Auto(default:Auto) |
Capacity | Capacity of currently installed hard disk. |
Hard drive information should be labeled on the outside drive casing. Enter the appropriate option based on this information.
Cylinder | Number of cylinders |
Head | Number of heads |
Precomp | Write precomp |
Landing Zone | Landing zone |
Sector | Number of sectors |
Drive A / Drive B
The category identifies the types of floppy disk drive A or drive B that has been installed in the computer.
None
360K, 5.25" 
1.2M, 5.25"
720K, 3.5"
1.44M, 3.5" 
2.88M, 3.5"
Halt on
The category determines whether the computer will stop if an error is detected during power up.
No Errors | The system boot will not stop for any error that may be detected and you |
| will be prompted. |
All Errors | Whenever the BIOS detects a |
All, But Keyboard | The system boot will not stop for a keyboard error; it will stop for all other |
| errors. (Default value) |
All, But Diskette | The system boot will not stop for a disk error; it will stop for all other errors. |
All, But Disk/Key | The system boot will not stop for a keyboard or disk error; it will stop for all |
| other errors. |
Floppy 3 Mode Support (for Japan Area)
Disabled | Normal Floppy Drive. (Default value) |
Drive A | Drive A is 3 mode Floppy Drive. |
English
- 33 - | BIOS Setup |