Gigabyte GA-8I865PEM-775 user manual Integrated Peripherals, Sata Port1 configure as

English

2-3	Integrated Peripherals
		CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
				Integrated Peripherals
	On-Chip Primary PCI IDE			[Enabled]		Item Help
	On-Chip Secondary PCI IDE			[Enabled]		Menu Level`
	On-Chip SATA			[Auto]
x	SATA Port0 configure as			SATA Port0
	SATA Port1 configure as			SATA Port1
	USB Controller			[Enabled]
	USB 2.0 Controller			[Enabled]
	USB Keyboard Support			[Disabled]
	USB Mouse Support			[Disabled]
	AC97 Audio			[Auto]
	Onboard H/W LAN			[Enabled]
	Onboard LAN Boot ROM			[Disabled]
	Onboard Serial Port 1			[3F8/IRQ4]
	Onboard Serial Port 2			[2F8/IRQ3]
	UART Mode Select			[Normal]
x	UR2 Duplex Mode			Half
	Onboard Parallel Port			[378/IRQ7]
	Parallel Port Mode			[PRINTER]
x	ECP Mode Use DMA			3
KLJI: Move		Enter: Select		+/-/PU/PD: Value	F10: Save	ESC: Exit	F1: General Help
	F5: Previous Values			F6: Fail-Safe Defaults		F7: Optimized Defaults
	On-Chip Primary PCI IDE
	Enabled		Enable onboard 1st channel IDE port. (Default value)
	Disabled		Disable onboard 1st channel IDE port.
	On-Chip Secondary PCI IDE
	Enabled		Enable onboard 2nd channel IDE port. (Default value)
	Disabled		Disable onboard 2nd channel IDE port.
	On-Chip SATA
	Disabled		Disable onboard Seria ATA function.
	Auto		When there is no device to be plugged in IDE1 or IDE2, SATA controller will
			remap to IDE controller. (Default value)
	Manual		Set SATA mode manually from "SATA Port0 configure as" item.
	SATA Port0 configure as
	IDE Pri. Master		Set SATA controller to compatible mode. This mode will remap SATA Port 0 to
			IDE Primary Master.
	IDE Pri. Slave		Set SATA controller to compatible mode. This mode will remap SATA Port 0 to
			IDE Primary Slave.
	IDE Sec. Master		Set SATA controller to compatible mode. This mode will remap SATA Port 0 to
			IDE Secondary Master.
	IDE Sec. Slave		Set SATA controller to compatible mode. This mode will remap SATA Port 0 to
			IDE Secondary Slave.
	SATA Port0		Set SATA controller to native mode(Serial ATA mode - SATA Port 0). This mode
			is only supported by Windows XP or later. (Default value)
	SATA Port1		Set SATA controller to native mode(Serial ATA mode - SATA Port 1). This mode
			is only supported by Windows XP or later.

SATA Port1 configure as

The setting depends on "SATA Port0 configure as" item setting. (Default: SATA Port1)

GA-8I865PEM-775 Motherboard - 34 -