26
Getting Ready to Install
As noted previously, you can install the server in a
Important: Check the documentation for your rack for any special requirements.
Before beginning work with the server and rack, make the following preparations.
•If possible, arrange to work with another person as you prepare the server and install it in a rack.
•Assemble the tools, brackets, and connectors you’ll need for the installation. (Everything except the screwdrivers is provided with the server.)
•A
•A very small Phillips screwdriver (such as size 0, needed for a
•For a
•For a
•For a
Note: Two sets of screws are provided with the server. One set (English) is size
•To measure and mark the position of the server in the rack, you may want to use a straightedge, such as a yardstick. You’ll also need a pen or pencil and some masking tape or similar tape.
•Clear a table, cart, or other flat surface near the rack. You’ll need to put the server on it temporarily during installation, and you can use it to lay out the brackets and screws you’ll use to attach the server to the rack.
Chapter 3 Installing Your Server in a Rack