7Slide the brace forward or backward so that the flat end of the brace is flush with the back post of the rack, and screw the brace’s flange to the post.
Attach the cover to the two rear rack posts using four of the screws provided.
8Attach the second bracket and brace, as described in steps 3 through 7.
Note: If your rack is deeper than the server, the braces and brackets extend beyond the server’s back panel to the rack’s posts.
Place the Server in the Rack
Once you’ve attached the cover, you can put the server into the rack.
1At the front of the rack, lift the server to the level where the enclosure’s cover is installed and slide the server into the cover.
36
Insert the server into the cover and slide it all the way back.