Quick Installation
1With the UPS disconnected from utility power, use a small tool to set the Voltage DIP Switches to match your input voltage (UPS is preset to the 120V setting).
2Plug the UPS into an outlet on a dedicated circuit.*
NOTE! after you plug the UPS into a live AC outlet, the UPS (in “Standby” mode) will automatically charge its batteries,** but will not supply power to its outlets until it is turned ON (see Step 3 below).
*Includes an additional plug which can be switched by a qualified electrician. ** The BATTERY CHARGE LED will be the only LED illuminated.
3Plug your equipment into the UPS.*
* Your UPS is designed to support only electronic equipment. You will overload the UPS if the total VA ratings for all the equipment you con- nect exceeds the UPS's Output Capacity. To find your equipment's VA ratings, look on their nameplates. If the equipment is listed in amps, multiply the number of amps by 120 to determine VA. (Example: 1 amp × 120 = 120 VA). If you are unsure if you have overloaded the UPS's out- lets, see “OUTPUT LOAD LEVEL” LED description.
4Turn the UPS ON.
Press and hold the “ON/OFF/STANDBY” button for one second. The alarm will beep once briefly after one second has passed. Release the button.
1 |
2 |
3 |
4 |
5