Tripp Lite 725 owner manual Storage & Service, Specifications

Page 6

Storage & Service

Storage

First turn your UPS OFF and disconnect its power cord from the wall outlet. Then disconnect all equipment to avoid battery drain. If you plan on storing your UPS for an extended period of time, fully recharge the UPS batteries once every three months by plugging the UPS into a live AC outlet and letting the UPS charge for 4 to 6 hours. If you leave your UPS batteries discharged for an extended period of time, they will suffer a permanent loss of capacity.

Service

If returning your UPS for service, contact your local Tripp Lite dealer or distributor. They will refer you to a service center. Please carefully pack the UPS using the ORIGINAL PACKING MATERIAL that came with the unit. Enclose a letter describing the symptoms of the problem. If the UPS is within the warranty period, enclose a copy of your sales receipt.

Specifications

 

OMNISMART725

Output Capacity (VA/Watts):

725/425

Battery Runtime (Half Load/

 

Full Load) Minutes:

17/5

Battery Recharge Time:

2-4 hrs.

Approvals:

UL, cUL, NOM

Modem/Fax Protection

 

(starts at 260V):

2 line

Input Voltage/Frequency (120V/60 Hz); On-Line Input Voltage Range (75 - 147 volts); Voltage-Regulated Output Voltage Range (120V +7%

/-18%); On Battery Output Voltage Range (120V ±5%); Output Waveform Line Mode (filtered sinewave); Output Waveform Battery Mode (PWM sine wave); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40 dB); AC Protection Modes (H to N, H to G, N to G).

FCC Part 68 Notice (U.S. only)

If your Modem/Fax Protection causes harm to the telephone network, the Telephone Company may temporarily discontinue your service. If possible, they will notify you in advance. If advance notice isn’t practical, you will be notified as soon as possible. You will be advised of your right to file a complaint with the FCC. Your telephone company may make changes in its facilities, equipment, operations or procedures that could affect the proper operation of your equipment. If it does, you will be given advance notice to give you an opportunity to maintain uninterruptedservice.IfyouexperiencetroublewiththisModem/FaxProtectionequipment,pleasecontacttheManagerofTechnicalSupport, Tripp Lite; 1111 W. 35th Street, Chicago, Illinois 60609; Phone: (773) 869-1234, for repair/warranty information. The telephone company may askyoutodisconnectthisequipmentfromthenetworkuntiltheproblemhasbeencorrectedoryouaresuretheequipmentisnotmalfunctioning. TherearenorepairsthatcanbemadebythecustomertotheModem/FaxProtection.Thisequipmentmaynotbeusedoncoinserviceprovided by the telephone company. Connection to party lines is subject to state tariffs. (Contact your state public utility commission or corporation commission for information.)

FCC Radio/TV Interference Notice

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Theselimitsaredesignedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidentialinstallation.Thisequipmentgenerates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause interference toradiocommunications.However,thereisnoguaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoescause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference using one or more of the following measures: reorient or relocate the receiving antenna; increase the separation betweentheequipmentandreceiver;connecttheequipmentintoanoutletonacircuitdifferentfromthatwhichthereceiverisconnected;consult the dealer or an experienced radio/television technician for help. The user must use shielded cables and connectors with this product. Any changes or modifications to this product not expressly approved by the party responsible for compliance could void the user's authority to operatetheequipment.

6

Image 6
Contents Quick Installation UPS Location Warnings SafetyBattery Warnings UPS Connection Warnings Quick Installation Switch Optional Installation† Test your UPSs battery charge SwitchesSilence the UPS On-Battery alarm Basic OperationIndicator Lights Other UPS FeaturesService Storage & ServiceSpecifications StorageInstalación Rápida Advertencias Sobre la Conexión SeguridadAdvertencias Sobre la Instalación Advertencias Sobre la Conexión de EquiposInstalación Rápida Interruptores Silenciar de la alarma de apagonesOperación Básica Posición on encendidoLuces Indicadoras Arrancar en frío el no-break / sistema UPSContactos Telefónicos Tipo RJ11 Otras Características de este No-break / Sistema UPSReceptáculos de CA Puerto DB9Almacenaje Almacenaje y ServicioEspecificaciones ServicioInstallation Rapide Recommandations relatives à la Connexion du Matériel Recommandations Relatives à l’Emplacement de lUPSRecommandations Relatives à la Connexion de lUPS Recommandations relatives à la BatterieInstallation Rapide Installation Facultative -†Commutateurs Amortir l’alarme du système d’UPSOpération de Base Tester la charge de la batterie de votre système d’UPSVoyants de Signalisation Autres Dispositifs d’UPSRéceptacles C.A Entreposage Entreposage & ServicePorte de Remplacement de la Batterie Prises Jacks de téléphone RJ11Caractéristiques Protection Modem/Fax Commence à Lignes