Moxa Technologies CP-102U/UL user manual Configuring the Ports

CP-102U/UL User’s Manual Software Installation

10.The Found New Hardware window will reappear and indicate that the board’s ports are being installed.

11.The installation procedure is finished when the window closes. At this point, you can assume that the board and all of its ports have been installed successfully.

Configuring the Ports

After the driver has been installed, use Device Manager to configure the CP-102U/UL serial ports.

1.Click on Start # Settings # Control Panel # System, select the Hardware tab, and then click on Device Manager.

2.Expand the Multi-port serial adapters tab, right click on MOXA CP-102U/UL Series (PCI Bus), and then click on Properties to open the board’s configuration panel.

3-19