Pelco CM6800E-48X8 manual Ports SERIAL/COM Ports, Serial Port Input on CM6800E rear panel

PORTS (SERIAL/COM PORTS)

Use the Port screen to configure the settings for each device connected to a Serial/COM port on the rear panel of the CM6800E.

PELCO SWITCHER

MODEL CM6800E

MAIN MENU

1	CAMERA	SET SERIAL PORT 05
2	LOGICAL CAMERA
3	MONITOR	DEVICE:	KBD300
4	ACCESS
		TYPE:	RS485
5	TIME & DATE
6	PORT	BAUD RATE:	9600
7	PRIORITY	PARITY:	ODD
8	SEQUENCE	DATA BITS:	8
9	MACRO
		STOP BITS:	1
10	ALARM CONTACTS
11	EVENT TIMER	REPORT ALARMS:	- - -
12	SET AUXILIARY
13	SET PASSWORD	RETURN
14	SYSTEM
15	ABOUT CM6800E

ENGLISH

RETURN

Figure 46. Port Screen

1.Select the number of the desired Serial Port/COM port (01-10). The serial port numbers correspond to the communication ports on the CM6800E rear panel as follows:

Serial Port	Input on CM6800E rear panel
01	COM 1 (accessed through either the DB9 input or RJ-45 port)
02-08	COM 2-8 RJ-45 inputs
09	PTZ-A control input
10	PTZ-B control input

2.Select the device connected to the COM port; the values in the TYPE, BAUD RATE, PARITY, DATA BITS, and STOP BITS fields change to the settings appropriate for the specific device.

NOTE: “KBD300” is used to refer to the KBD100, KBD200A, and KBD300A keyboards.

3.Optional: Some device options allow a choice of communication type, baud rate, and/or parity rate. If this is the case, select the desired settings.

4.Optional: If you select an ASCII device or if you use the CM6800E as a satellite device in a CM9760 system, you can select ON in the Report Alarm field to set the CM6800E to report alarms to that device. The CM6800E reports the following alarm information:

Action	ASCII text
An alarm is triggered	#Ea
An alarm is cleared	#Ia
An alarm is acknowledged	#Ka

NOTE: The alarm number (#) reported by the CM6800 is based on the logical alarm number defined in the Logical Alarm Number screen. Refer to Assign a Logical Alarm Number in the Alarm Programming section.

C1528M-F (6/05) 59