Pelco CM6800E-48X8 manual Software Reset, Dip Switch Cover Plate

SOFTWARE RESET

Pelco strongly recommends uploading system settings to the CM6800E-
MGR before the software reset – this will allow you to restore system
settings after the software reset.	010101

1 2 3 4 5 6 7 8

CAUTION: Resetting the software restores the system to default settings.

1

2

31 32 3

5

6

7

A T T

+ -

CONTROL

R R T T - + + -

R R B - +

F

4

4

8

1

2

3

1.Remove the two screws and the DIP switch cover plate from the rear of the switcher.

2.Move DIP switch 7 to the ON position (to “0”).

3.Cycle power.

The switcher will go through a software clear cycle and reset to factory defaults.

4.Move DIP switch 7 to the OFF position.

Failure to move DIP switch 7 to the OFF position could result in loss of system settings during a power outage.

5.Re-initialize keyboards by entering the monitor number and then pressing the MON key.

6.Download your previous system settings (revise settings as necessary) from the CM6800-MGR.

1

7 8

120/230~ 50/60 HZ 25 WATTS

DIP SWITCH

COVER PLATE

Figure 64. Dip Switch Cover Plate

SWITCH 7:

ON = SOFTWARE RESET

OFF = NORMAL SYSTEM

OPERATION

Figure 65. CM6800E DIP Switch 7

C1528M-F (6/05) 95