Pelco FR82041 manual Installation, Package Contents

Page 11

Installation

PACKAGE CONTENTS

The following items are supplied:

1FT82041 or FR82041 module

1Regulated switching power supply with four plug adapters (North American, Australian, U.K., and European configurations); 100-240 VAC, 50-60 Hz input, 12 VDC output

1Wall clip with two 4-40 x 0.250-inch Phillips pan head screws with lock washers (for attachment of single module to wall)

1FT82041/FR82041 Fiber Transmitter and Receiver Installation manual

SETTING 10BASE-T/100BASE-TX PORT MODES OF OPERATION

NOTE: As a matter of convenience, it is recommended that you verify the modes of operation for each 10BASE-T/100-BASE-TX port and then change the mode settings—if necessary—before mounting the FT82041/FR82041 module into a rack or onto a wall.

The FT82041/FR82041 module provides various configuration options that allow you to select the desired modes of operation for each 10BASE-T/100BASE-TX port (ports 1-4). You can select the desired modes of operation by means of a TX Mode switch that is provided on the bottom of the module for each port (refer to Figure 4).

TX MODE SWITCHES - PORTS 1-4

TX Mode

L

L

Figure 4. TX Mode Switches for 10BASE-T/100BASE-TX Ports 1-4

C2623M (2/07)

11

Image 11

Contents FT82041/FR82041 Unmanaged Ethernet Switch Page List of Tables ContentsList of Illustrations Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory NoticesDescription Product OverviewSingle-Mode Models*† ModelsMultimode Models 100BASE-FX Status LED Power LED Pelco badgeFront Panel RK5000PS-5U rack mount chassisRear Panel 10BASE-T/100BASE-TX Ports 1-4 RJ-45 connectorsPackage Contents Installation10BASE-T/100BASE-TX Modes of Operation Autonegotiation is enabled by defaultFlow control default setting Mounting the FT82041/FR82041 Module Into a Rack MountingMounting the FT82041/FR82041 Module Using the Wall Clip 10BASE-T/100BASE-TX connections ConnectionsFiber connection Troubleshooting Meaning Possible Cause Corrective Action Optic Fault LED 11 for information Table C. Troubleshooting with Rear-Panel IndicatorsDesired, refer to Setting Amber 10BASE-T link is If 10BASE-T operation is EstablishedMeaning Possible Cause Corrective Action Flashing amber Port is set to Normal or excessive Refer to SettingIf half-duplex mode is Amber Port is set to100BASE-TX half Duplex mode LinkGreen Port is set to If 100BASE-TX full-duplex Flashing green Port is set toTable C. Troubleshooting with Rear-Panel Indicators Link/activity and speed, duplex/collision and speed SpecificationsMultimode 62.5/125 μm Model Number Wavelength Optical Maximum Transmit/ReceiveReceiver EndIllustrates RJ-45 MDI/MDI-X connector pinouts Appendix. RJ-45 Connector PinoutsProduct Warranty and Return Information ISO9001