Pelco FR82041 manual Green Port is set to If 100BASE-TX full-duplex, Flashing green Port is set to

Table C. Troubleshooting with Rear-Panel Indicators (Continued)

Indicator Color	Meaning	Possible Cause		Corrective Action
RJ-45 10BASE-T/100BASE-TX Port Status LED - Right (Duplex/Collision) (Continued)
Green	Port is set to	—	If 100BASE-TX full-duplex
	100BASE-TX full-		operation is desired, no action
	duplex mode.		is required. If 100BASE-TX
			full-duplex operation is not
			desired, refer to Setting
			10BASE-T/100BASE-TX Port
			Modes of Operation on
			page 11 for information.
Flashing green	Port is set to	Normal or excessive colli-	If a normal collision occurs, no
	100BASE-TX half-	sions occur on a half-duplex	action is required.
	duplex mode and	link.*	If a problem with the network
	network collision		exists due to excessive colli-
	has occurred.*		sions, do any of the following
			as appropriate:
			• If half-duplex mode is not
			required, set the TX Mode
			switch to full-duplex mode
			by means of autonegotia-
			tion or by forcing the mode
			(refer to Setting
			10BASE-T/100BASE-TX
			Port Modes of Operation
			on page 11 for
			information).
			• If half-duplex mode is
			required, do any of the
			following as applicable:
			– Replace cable if it is
				defective or if it is not
				the proper cable type.
				Use Cat5e or higher
				cable.
			– Ensure that cable is the
				proper length. Cable
				length must not exceed
				328 feet (100 meters).
			–	Replace the network
				interface card (NIC) if it
				is defective or if it is
				incompatible.
			–	Segment the network.
				(Continued on next page)

22 C2623M (2/07)