Pelco C2622M manual Ethernet Switch

Page 1

I N S T A L L A T I O N

	FX82051 Unmanaged
®	Ethernet Switch

Five 10BASE-T/100BASE-TX Ports and One 100BASE-FX Fiber Port

C2622M (2/07)

Image 1

Contents Ethernet Switch List of Illustrations ContentsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory NoticesDescription Product OverviewFX82051 module consists of the following series of models ModelsMultimode Models Single-Mode Models*†Front Panel Power LED Pelco badge100BASE-FX Status LED Rear Panel 10BASE-T/100BASE-TX Ports 1-5 RJ-45 connectorsPackage Contents InstallationFlow control is disabled by default Autonegotiation is enabled by defaultFlow control default setting Table A. TX Mode Switch Settings10BASE-T/100BASE-TX Modes of Operation Mounting the FX82051 Module Into a Rack MountingMounting the FX82051 Module Using the Wall Clip 10BASE-T/100BASE-TX connections ConnectionsFiber connections Fiber Port Connections in Point-to-Point Application Troubleshooting Meaning Possible Cause Corrective Action Optic Fault LED Desired, refer to Setting Table C. Troubleshooting with Rear-Panel IndicatorsData is being Desired, refer to Setting Transmitted or AmberMeaning Possible Cause Corrective Action Duplex mode Duplex link Duplex modeIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplexFlashing green Port is set to Normal or excessive Green Port is set to If 100BASE-TX full-duplexReplace cable if it is Use Cat5e or higherTable C. Troubleshooting with Rear-Panel Indicators Duplex/collision and speed SpecificationsFX82051SSTR-2 Optical Maximum LaserIllustrates RJ-45 MDI/MDI-X connector pinouts Appendix. RJ-45 Connector PinoutsProduct Warranty and Return Information ISO9001