Pelco C2622M Table C. Troubleshooting with Rear-Panel Indicators, Amber, If 10BASE-T operation is

Page 19

Table C. Troubleshooting with Rear-Panel Indicators

Indicator Color	Meaning	Possible Cause	Corrective Action

RJ-45 10BASE-T/100BASE-TX Port Status LED - Left (Link/Activity)

Amber	A 10BASE-T link is	—	If 10BASE-T operation is
	established.		desired, no action is required.
			If 10BASE-T operation is not
			desired, refer to Setting
			10BASE-T/100BASE-TX Port
			Modes of Operation on
			page 10 for information.

Flashing amber	Data activity is	—	If 10BASE-T operation is
	occurring on the		desired, no action is required.
	10BASE-T link; data		If 10BASE-T operation is not
	is being transmitted		desired, refer to Setting
	or received.		10BASE-T/100BASE-TX Port
			Modes of Operation on
			page 10 for information.

Green	A 100BASE-TX link	—	If 100BASE-TX operation is
	is established.		desired, no action is required.
			If 100BASE-TX operation is not
			desired, refer to Setting
			10BASE-T/100BASE-TX Port
			Modes of Operation on
			page 10 for information.

Flashing green	Data activity is	—	If 100BASE-TX operation is
	occurring on the		desired, no action is required.
	100BASE-TX link;		If 100BASE-TX operation is not
	data is being		desired, refer to Setting
	transmitted or		10BASE-T/100BASE-TX Port
	received.		Modes of Operation on
			page 10 for information.

			(Continued on next page)

C2622M (2/07)

19

Image 19

Contents Ethernet Switch List of Illustrations ContentsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory NoticesDescription Product OverviewSingle-Mode Models*† ModelsFX82051 module consists of the following series of models Multimode ModelsFront Panel Power LED Pelco badge100BASE-FX Status LED Rear Panel 10BASE-T/100BASE-TX Ports 1-5 RJ-45 connectorsPackage Contents InstallationFlow control is disabled by default Autonegotiation is enabled by defaultFlow control default setting Table A. TX Mode Switch Settings10BASE-T/100BASE-TX Modes of Operation Mounting the FX82051 Module Into a Rack MountingMounting the FX82051 Module Using the Wall Clip 10BASE-T/100BASE-TX connections ConnectionsFiber connections Fiber Port Connections in Point-to-Point Application Troubleshooting Meaning Possible Cause Corrective Action Optic Fault LED Amber Table C. Troubleshooting with Rear-Panel IndicatorsDesired, refer to Setting Data is being Desired, refer to Setting Transmitted orMeaning Possible Cause Corrective Action Amber Port is set to If 10BASE-T full-duplex Duplex modeDuplex mode Duplex link If half-duplex mode isUse Cat5e or higher Green Port is set to If 100BASE-TX full-duplexFlashing green Port is set to Normal or excessive Replace cable if it isTable C. Troubleshooting with Rear-Panel Indicators Duplex/collision and speed SpecificationsFX82051SSTR-2 Optical Maximum LaserIllustrates RJ-45 MDI/MDI-X connector pinouts Appendix. RJ-45 Connector PinoutsProduct Warranty and Return Information ISO9001