Pelco C2622M manual Mounting the FX82051 Module Using the Wall Clip

Page 14

Mounting the FX82051 Module Using the Wall Clip

NOTE: Before mounting the FX82051 module to a wall, ensure that there is adequate space at both ends for viewing the front-panel LEDs and for making the various rear-panel cable connections.

To attach the FX82051 module to a wall using the supplied wall clip, refer to Figure 5 and do the following:

1.Using the two vertical or horizontal wall-mounting holes, attach the wall clip to a wall using two screws (not provided).

2.Slide the module into the clip until the two holes on the bottom of the module align with the two holes on the lower flange of the clip.

3.Attach the module to the clip using the two Phillips pan head screws provided for the clip.

UPPER

FLANGE

VERTICAL

MOUNTING HOLE (2)

HORIZONTAL

MOUNTING HOLE (2)

SCREW, PHILLIPS	LOWER
SCREW, PHILLIPS	FLANGE
PAN HEAD WITH	WALL CLIP
PAN HEAD WITH
LOCK WASHER (2)

Figure 5. Mounting the FX82051 Module Using the Wall Clip

14	C2622M (2/07)

Image 14

Contents Ethernet Switch List of Tables ContentsList of Illustrations Important Safety Instructions Risk of Electric Shock Do not Open Regulatory Notices Radio and Television InterferenceProduct Overview DescriptionMultimode Models ModelsFX82051 module consists of the following series of models Single-Mode Models*†100BASE-FX Status LED Power LED Pelco badgeFront Panel 10BASE-T/100BASE-TX Ports 1-5 RJ-45 connectors Rear PanelInstallation Package ContentsAutonegotiation is enabled by default Flow control is disabled by default10BASE-T/100BASE-TX Modes of Operation Table A. TX Mode Switch SettingsFlow control default setting Mounting Mounting the FX82051 Module Into a RackMounting the FX82051 Module Using the Wall Clip Fiber connections Connections10BASE-T/100BASE-TX connections Fiber Port Connections in Point-to-Point Application Troubleshooting Meaning Possible Cause Corrective Action Optic Fault LED Data is being Desired, refer to Setting Transmitted or Table C. Troubleshooting with Rear-Panel IndicatorsDesired, refer to Setting AmberMeaning Possible Cause Corrective Action If half-duplex mode is Duplex modeDuplex mode Duplex link Amber Port is set to If 10BASE-T full-duplexReplace cable if it is Green Port is set to If 100BASE-TX full-duplexFlashing green Port is set to Normal or excessive Use Cat5e or higherTable C. Troubleshooting with Rear-Panel Indicators Specifications Duplex/collision and speedOptical Maximum Laser FX82051SSTR-2Appendix. RJ-45 Connector Pinouts Illustrates RJ-45 MDI/MDI-X connector pinoutsProduct Warranty and Return Information ISO9001