Pelco C2622M manual Optical Maximum Laser, FX82051SSTR-2

Page 25

OPTICAL POWER BUDGET, TRANSMISSION DISTANCE, AND LASER CLASS 1 LIMIT

		Optical		Maximum	Laser
	Wavelength	Power		Transmission	Class 1
Model Number	(Transmit/Receive)	Budget		Distance	Limit*

	Multimode (62.5/125 μm)

FX82051MSTR-2	1310/1310 nm	26 dB†		6 km (3.7 mi)‡	<15.6 mW
FX82051MSCR-2	1310/1310 nm	26 dB†		6 km (3.7 mi)‡	<15.6 mW
	Single-Mode (9/125 μm)

FX82051SSTR-2	1310/1310 nm	28 dB		46 km (28.6 mi)§	<15.6 mW
FX82051SSCR-2	1310/1310 nm	28 dB		46 km (28.6 mi)§	<15.6 mW

* The FX82051 module is classified by the FDA as a Class 1 laser product.

† When using 50/125 μm multimode fiber, subtract 3 dB from the optical power budget.

‡ Maximum transmission distance is limited by fiber bandwidth.

§ Maximum transmission distance is based on attenuation of 0.5 dB/km plus a 5 dB buffer for connector and splice losses.

NOTES:

• Single-mode FC connector is available upon request. Contact the factory for additional information.

• For conformal coated models, replace the first letter F in the model number with the letter C. The conformal coated version of FX82051MSTR-2, for example, is CX82051MSTR-2.

• For models with higher optical power budgets, contact the factory.

C2622M (2/07)

25

Image 25

Contents Ethernet Switch List of Illustrations ContentsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory NoticesDescription Product OverviewFX82051 module consists of the following series of models ModelsMultimode Models Single-Mode Models*†Front Panel Power LED Pelco badge100BASE-FX Status LED Rear Panel 10BASE-T/100BASE-TX Ports 1-5 RJ-45 connectorsPackage Contents InstallationFlow control is disabled by default Autonegotiation is enabled by defaultFlow control default setting Table A. TX Mode Switch Settings10BASE-T/100BASE-TX Modes of Operation Mounting the FX82051 Module Into a Rack MountingMounting the FX82051 Module Using the Wall Clip 10BASE-T/100BASE-TX connections ConnectionsFiber connections Fiber Port Connections in Point-to-Point Application Troubleshooting Meaning Possible Cause Corrective Action Optic Fault LED Desired, refer to Setting Table C. Troubleshooting with Rear-Panel IndicatorsData is being Desired, refer to Setting Transmitted or AmberMeaning Possible Cause Corrective Action Duplex mode Duplex link Duplex modeIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplexFlashing green Port is set to Normal or excessive Green Port is set to If 100BASE-TX full-duplexReplace cable if it is Use Cat5e or higherTable C. Troubleshooting with Rear-Panel Indicators Duplex/collision and speed SpecificationsFX82051SSTR-2 Optical Maximum LaserIllustrates RJ-45 MDI/MDI-X connector pinouts Appendix. RJ-45 Connector PinoutsProduct Warranty and Return Information ISO9001