Discrete Outputs The following table contains specifications for discrete outputs.
Description | Solid state switch |
|
|
Operating Voltage | 16 - 42 VDC |
|
|
Absolute Minimum Voltage | 12 VDC |
|
|
Absolute Maximum Voltage | 45 VDC |
|
|
Maximum Voltage | 50 VDC for 1 ms |
|
|
Number of Points | 8 |
|
|
Number of Groups | 1 |
|
|
Points per Group | 8 |
|
|
Current Capacity | 250 mA per point 2 amps per module |
|
|
Type of Signal | True high (sourcing) |
|
|
Leakage Current | < 1 mA @ 42 VDC |
|
|
Surge Current | 5 amps for 1 ms |
|
|
On State Voltage Drop | < 1.0 VDC max at 0.25 amp current |
|
|
Fault Sensing | Overload and short circuit |
|
|
Fault Reporting | System bit |
|
|
Response Time | 1.8 ms OFF to ON |
| 1.8 ms ON to OFF |
|
|
CAUTION
Discrete VDC outputs incorporate thermal shutdown and overload protection.
The output current of a shorted output is limited to a nondestructive value. The short circuit heats the output driver, and the output will switch off. The output will switch on again if the driver leaves the over temperature condition and the user resets the output under program control. If the short circuit still exists after the output point is reset, the driver will reach the over temperature condition again and will switch off again.
Failure to follow this precaution can result in injury or equipment damage.
8 | 31005009 01 November 2003 |